User manual SONY KV-21CT1U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Make sure you insert the supplied batteries using the correct polarities. Always remember to dispose of used batteries in an environmental friendly way. For a better reception we recommend you connect an external aerial. However, where an external aerial is not available and your local UHF signal is strong, you can connect the supplied loop aerial as follows: 1 Insert the loop aerial into the opening on top of the set until it clicks. For more details of VCR connection, please refer to the section "Connecting Optional Equipment" of this instruction manual (see page 17). The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen, 2) search and store all available channels (TV Broadcast), 3) change the order in which the channels (TV Broadcast) appear on the screen and 4) adjust the picture slant (only for KV-21CT1U). However, if you need to change any of these settings at a later date, you can do that by selecting the appropriate option in the (Set Up) or (Channel Set Up) menu. The first time you switch on the TV, a Language menu displays automatically on the TV screen. Language Svenska Norsk English Nederlands Français Select language Select [­2+] Confirm [t] This procedure could take some minutes. Please be patient and do not press any buttons, otherwise automatic tuning will not be completed. If no channels were found during the auto tuning process, a new menu appears automatically on the screen asking you to connect the aerial. Programme Sorting menu appears automatically on the screen enabling you to change the order in which the channels appear on the screen. A) If you wish to keep the broadcast channels in the tuned order, B) If you wish to store the channels in a different order: 1 Press 2 +/­ to select the programme number with the channel (TV Broadcast) you wish to rearrange, then press t. 2 Press 2 +/­ to select the new programme number position for your selected channel (TV Broadcast), then press t. 3 Repeat steps b)1 and b)2 if you wish to change the order of the other channels. The following option is only available for KV-21CT1U. Because of the earth's magnetism, the picture might slant. The Picture Rotation menu allows you to correct the picture slants if it is necessary. B) If it is necessary, press 2 +/­ to correct any slant of the To allow this menu to appear again, press and hold MENU button at top control panel for about 5 seconds. The MENU, and / / / buttons on the remote control can also be used for the operations above. Your TV uses an on-screen menu system to guide you through the operations. Use the following buttons on the Remote Control to operate the menu system: The "Picture" menu allows you to alter the picture adjustments. [. . . ] To do this: While watching the channel (TV Broadcast) you wish to fine or to tune, select the AFT option and press . Next press adjust the fine tuning between -15 and +15. C) Skip any unwanted programme numbers when they are selected with the PROG +/­ button. to do this: Highlighting the Programme option , press PROG +/­ to select the programme number you want to skip. [. . . ]