User manual SONY KV-21FT1U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] If you wish to change the channel order: 1 Press the or button to select the programme number with the channel (TV Broadcast) you wish to rearrange, then press the button. 2 Press the or button to select the new programme number position for your selected channel (TV Broadcast), then press . 3 Repeat steps b)1 and b)2 if you wish to change the order of the other channels. Your TV is now ready for use Your TV uses an on-screen menu system to guide you through the operations. Use the following buttons on the Remote Control to operate the menu system: PICTURE ADJUSTMENT The "Picture Adjustment" menu allows you to alter the picture adjustments. To do that: after selecting the item you want to alter press , then press repeatedly / / or to adjust it and finally press OK to store the new adjustment. This menu also allows you to customise the picture mode based on the programme you are watching: Personal (for individual settings). Select Reset and press OK to reset the picture to the factory preset levels. SLEEP TIMER The "Sleep Timer" option in the "Timer" menu allows you to select a time period for the TV to switch itself automatically into the standby mode. To do that: after selecting the option press , then press or to set the time period delay (max. While watching the TV, you can press the button on the remote control to display the time remaining. ⷠOne minute before the TV switches itself into standby mode, the time remaining is displayed on the TV screen automatically. ON TIMER The "On Timer" option in the "Timer" menu allows you to select a time period for the TV to switch itself automatically on from standby mode. To do that: after selecting the option press , then press or to set the time period delay (max. Any loss of power will cause these settings to be cleared. LANGUAGE The "Language" option in the "Set Up" menu allows you to select the language that the menus are displayed in. To do that: after selecting the option, press and then proceed in the same way as in the step 2 of the section "Switching On the TV and Automatically Tuning". AUTO TUNING The "Auto Tuning" option in the "Set Up" menu allows you to automatically search for and store all available TV channels. To do that: after selecting the option, press and then proceed in the same way as in steps 4 and 5 of the section "Switching On the TV and Automatically Tuning". PROGRAMME SORTING The "Programme Sorting" option in the "Set Up" menu allows you to change the order in which the channels (TV Broadcast) appear on the screen. To do that: after selecting the option, press and then proceed in the same way as in step 6 b) of the section "Switching On the TV and Automatically Tuning". By one to the programme order of your choice. [. . . ] Then press or to adjust the centre of the picture between ­10 and +10. In this case, you can correct the pictures slant by using the option "Picture Rotation" in the "Advanced Features" menu. Then press or to correct any slant of the picture between -5 and +5 and finally press OK to store. The index page of the teletext service (usually page 100) gives you information on how to use the service. [. . . ]