User manual SONY KV-21FX20R

[. . . ] Before operating the TV, please read this manual thoroughly and retain it for future reference. Keys to read this Instruction Manual: · Use Getting Started if you wish to install the TV set and to get familiar with the basic functions. ⷠUse Advanced Operation if you wish to know more about the additional features of the TV set. Shaded buttons on the remote control show the buttons you have to press to follow the sequence of instructions. [. . . ] Press the PROGR or button until the channel (TV Broadcast) you wish to rearrange appears on the screen. Press the or button to select the new programme number position for your selected channel (TV Broadcast), then press the OK button. The word CONFIRM is highlighted for a few seconds to confirm that the new programme position is stored. Repeat steps 1 and 2 if you wish to change the order of the other channels on your TV. Besides the explanation in the section "Automatically Tuning the TV using the Remote Control", by following the instructions below, this TV also searches and stores automatically all available channels using just one button of the TV set. Press the flap on the front of the TV by pressing on the reveal the front control panel. Press and hold in the button on the TV set for some seconds, until a menu appears automatically on the screen asking you to check that antenna is connected. When the automatic tuning procedure is complete, the menu disappears from the TV screen and your TV is now ready for use. Use this function to preset channels or a video input source one by one to the programme order of your choice. Press the button to select the symbol, then press the button to enter to the SET UP menu. With the cursor highlighting PROGRAMME, press the button and then, press the or button to select on which programme number you want to preset a channel. Press the number buttons to enter the channel number of the TV Broadcast or press the or button to search for the next available channel. If you do not wish to store this channel, press the or button to continue searching for the desired channel. If this is the desired channel you wish to store, press the OK button and then, with the cursor highlighting CONFIRM, press the OK button again. Repeat steps 4 to 8 if you wish to store more channels. If the picture is distorted, however, you can manually fine tune the TV to obtain a better picture reception. Select the channel (TV Broadcast) you wish to fine tune, then press the MENU button on the remote control to display the menu on the TV screen. Repeat steps 1 to 7 to fine tune other channels. Because of the earth's magnetism, the picture might slant. In this case, you can correct the picture slanting. [. . . ] If you use the "Wake Up Timer" to switch the TV on and keep it on for one hour without pressing any TV or remote control button, the TV switches itself back into Standby mode and the indicator on the TV lights. ⷠAny temporary power failure causes a misfunction in the "Wake Up Timer" and you will have to reset the "Wake Up timer". Make sure to use a TV channel with a strong signal, otherwise teletext errors may occur. Select the TV channel which carries the teletext service you wish to view. [. . . ]