User manual SONY KV-24FV300

[. . . ] Connecting Additional Equipment 4-086-343-22 Operating Instructions KV-20FV300 KV-24FV300 © 2002 by Sony Corporation Connecting Additional Equipment To reduce the risk of fire or electric shock, do not expose the TV to rain or moisture. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN NOTIFICATION This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Press to jump back and forth between two channels. The TV alternates between current channel and the last channel that was selected. Press for a direct selection of Effect settings (Simulated, WOW, SRS, Off) (see page 20). Press to return to factory settings while in an on-screen menu. Press when you want to adjust the volume. Use to program your remote control to operate connected video equipment (see page 32). Press when you want to turn connected equipment on or off. Press when you want to control connected equipment with your remote control. Use when you want to operate connected VCR or DVD with your remote control. Press once to show current time (if set) and channel number. Cycles through the Multi-channel TV Sound (MTS) options: Stereo, Mono, and Auto SAP (Second Audio Program). Press 0 9 buttons to select a channel, then press ENTER. Brings up the custom guide of your satellite receiver. Moves the cursor in the on-screen menus. Press the arrow buttons to move the cursor. Press the center button to select or access an option. 7 8 RESET 9 VOL (volume) 0 CODE SET qa POWER qs FUNCTION qd VCR/DVD (operating) qf TV/VIDEO qg DISPLAY qh MTS/SAP qj 0 9 and ENTER qk GUIDE ql w; MENU wa CH (channel) Displays the on-screen menu. Press again to exit the menu at any time. Press when you want to change channels. If you lose your remote control, see page 36. 13 Operating Instructions Setting Up the TV Automatically After you have finished connecting your TV, you can perform Auto Program to set up your channels. 1 Press TV to turn on the TV. The Initial Setup screen appears. Initial Setup First please connect cable / antenna Auto Program Exit [CH+] [CH­] 2 Press press on the remote control or on the TV front panel to perform Auto Program, or to exit. To perform Auto Program again 1 2 3 4 5 14 The Initial Setup screen appears each time you turn on the TV until you perform Auto Program. Press . to exit. Press g to highlight Channel Setup ( Press f to highlight Cable. Press Press F or f to select On or Off according to how you connected your TV. Press Press f to highlight Auto Program. [. . . ] Adjust Brightness in the Picture Controls menu under Video (page 19). Check the antenna and/or cable connections (page 4). Press so that MUTING disappears from the screen (page 13). Your TV may be set to Auto-SAP or your Speakers might be Off (page 21). [. . . ]