User manual SONY KV-24LS35U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Volume level changes according to the broadcast signal. Volume level of the channels will stay the same, independent of the broadcast signal (e. Select Reset and press OK to reset the sound to the factory preset levels. â· In case of a bilingual broadcast select Dual Sound and set A for sound channel 1, B for sound channel 2 or Mono for mono channel if available. For a stereo broadcast you can choose Stereo or Mono. â· If you are listening to the TV through headphones, "Dolby Virtual" option will automatically be switched to "Off". * This TV has been designed to create the "Dolby Surround" sound effect by simulating the sound Of four speakers with two speakers, when the broadcast audio signal is Dolby Surround encoded. The sound effect can also be improved by connecting a suitable external amplifier (for details refer to "Connecting to external audio Equipment" on page 19). SLEEP TIMER The "Sleep Timer" option in the "Timer" menu allows you to select a time period for the TV to switch itself automatically into the standby mode. To do this: after selecting the option press , then press or to set the time period delay (max. While watching the TV, you can press the button on the remote control to display the time remaining. â· One minute before the TV switches itself into standby mode, the time remaining is displayed on the TV screen automatically. ON TIMER The "On Timer" option in the "Timer" menu allows you to select a time period for the TV to switch itself automatically on from standby mode. To do this: after selecting the option press , then press or to set the time period delay (max. Any loss of power will cause these settings to be cleared. If you have not activated the "On Timer" option but the indicator on the TV set flashes, please contact to your nearest Sony Service Centre. LANGUAGE The "Language" option in the "Set Up" menu allows you to select the language that the menus are displayed in. To do this: after selecting the option, press and then proceed in the same way as in the step 2 of the section "Switching On the TV and Automatically Tuning". AUTO TUNING The "Auto Tuning" option in the "Set Up" menu allows you to automatically search for and store all available TV broadcast channels. To do this: after selecting the option, press and then proceed in the same way as in TV steps 4 and 5 of the section "Switching On the TV and Automatically Tuning". PROGRAMME SORTING The "Programme Sorting" option in the "Set Up" menu allows you to change the order in which the broadcast channels appear on the screen. To do this: after selecting the option, press and then proceed in the same way as in step 6 b) of the section "Switching On the TV and Automatically Tuning". [. . . ] If your selected code is entered correctly, all three green lights will be lit momentarily. Turn on your brand VCR or DVD and check that the main functions work. â· If your device is not working or some of the functions do not work please check you entered the correct code set or try the next code listed against the brand. â· Your brand codes may be lost if weak batteries are not replaced within a few minutes. [. . . ]