User manual SONY KV-27FS100L

[. . . ] Connecting Additional Equipment 4-094-813-22 Operating Instructions KV-27FS100L © 2003 by Sony Corporation User Guide Connecting Additional Equipment WARNING To reduce the risk of fire or electric shock, do not expose the TV to rain or moisture. To reduce the risk of electric shock, do not use this polarized plug with an extension cord, receptacle, or other outlet unless the blades can be fully inserted to prevent blade exposure. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION RISQUE DE CHOC ELECTRIQUE, NE PAS OUVRIR You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. PRECAUCION RIESGO DE CHOQUE ELECTRICO NO ABRIR NOTIFICATION This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] If you subscribe to that kind of cable service, use this connection. If some, but not all, of your channels are scrambled, consider using the cable box and cable connection (see page 12). Cable box 1 From cable/ antenna Rear of TV 1 S VIDEO 3 Y 4 AUDIO OUT (VAR/FIX) PB PR 2 VIDEO L (MONO) L (MONO) R R 1 2 Connect the coaxial cable from your cable service to the IN jack on your cable box. Connect a coaxial cable (not supplied) from the OUT jack on your cable box to the VHF/UHF jack on your TV. Using your TV with this connection This connection allows you to do the following: Program your Sony remote control to operate your cable box (see page 5). To activate your remote press to operate your cable box and then use the 0 9 buttons or CH+/- buttons to change the channels. To do this, first program your remote control, then use the Channel Fix feature to set your TV to channel 3 or 4 (see page 27). 13 Operating Instructions Connecting a TV and Satellite Receiver From cable/ antenna Rear of TV 1 S VIDEO PB 2 3 Y 4 AUDIO OUT (VAR/FIX) 1 Satellite antenna cable Satellite receiver VIDEO L (MONO) PR L L (MONO) R R R 3 Video (yellow) Audio L (white) Audio R (red) 1 2 3 Connect the cable from your satellite antenna to SATELLITE IN on your satellite receiver. Connect the coaxial cable from your cable service or antenna to the VHF/UHF jack on your TV. Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your satellite receiver to AUDIO/VIDEO IN on your TV. Using your TV with this connection This connection allows you to do the following: Program your Sony remote control to operate your satellite receiver (see page 5). To activate your remote, press to operate your satellite receiver. See page 7 on how to operate other functions. Press repeatedly to switch to satellite receiver input (VIDEO input). 14 Connecting Your TV Connecting a TV, VCR, and Satellite Receiver 4 1 Rear of TV 1 S VIDEO PB From cable/ antenna 3 Y 4 AUDIO OUT (VAR/FIX) 2 VCR PR VIDEO L (MONO) L L (MONO) R R R Satellite receiver 3 5 Video (yellow) Audio L (white) Audio R (red) 1 2 3 4 5 Connect the coaxial cable from your satellite antenna to SATELLITE IN on the satellite receiver. Connect the coaxial cable from your cable service or antenna to the IN jack on your VCR. Using a coaxial cable (not supplied), connect the OUT jack on your VCR to the VHF/UHF jack on your TV. Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your satellite receiver to AUDIO/VIDEO IN on your VCR. Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your VCR to AUDIO/VIDEO IN on your TV. To view from the satellite receiver or VCR, select the video input to which your satellite receiver or VCR is connected by pressing on the remote control. Using your TV with this connection This connection allows you to do the following: Program your Sony remote control to operate your VCR or satellite receiver (see page 5). Turn on your VCR to enable your satellite receiver to work with this connection. To activate your remote, press to operate your VCR or to operate your satellite receiver. Press repeatedly to switch between VCR input (VIDEO input), VHF/UHF (local channels or unscrambled), or your cable box (cable system or scrambled channels). 15 Operating Instructions Connecting a DVD Player Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your DVD player to AUDIO/VIDEO IN on your TV. Rear of DVD Player Rear of TV 1 S VIDEO PB 3 Y 4 AUDIO OUT (VAR/FIX) PR VIDEO L (MONO) L L (MONO) R R R Video (yellow) Audio L (white) Audio R (red) Optional connection For better picture quality, use S VIDEO instead of the yellow video cable. S VIDEO does not provide sound, so you still must connect the audio cables. If your DVD player is equipped with component video outputs (Y, PB, PR), you can improve the picture quality by using component video cables (480i only). Rear of TV Rear of DVD Player 1 S VIDEO PB 3 Y 4 AUDIO OUT (VAR/FIX) PR VIDEO L (MONO) L L (MONO) R R R PR (red) PB (blue) Y (green) Audio L (white) Audio R (red) 2 1 1 2 Using component video cables (not supplied), connect the Y, PB, PR OUT on your DVD player to Y, PB, PR IN on your TV. Connect AUDIO OUT on your DVD player to AUDIO IN on your TV. The Y, PB, PR outputs on your DVD player are sometimes labeled Y, CB, and CR or Y, B-Y, and R-Y. If so, connect the cables to like colors. Using your TV with this connection This connection allows you to do the following: Program your Sony remote control to operate your DVD (see page 5). To activate your remote, press to operate your DVD. [. . . ] Check the TV/VIDEO setting: when watching TV, set it to TV; when watching video equipment, set it to VIDEO 1, 2, 3 or 4 (page 4). Make sure you have inserted the batteries correctly into the remote control (page 2). Try another channel to rule out station trouble. Adjust the Picture setting in the Video menu (page 24). [. . . ]