User manual SONY KV-27FS13

[. . . ] ⷠTo avoid battery leakage and damage to the remote, remove the batteries from the remote if you are not going to use it for several days. If any liquid leaks from the batteries and touches your skin, immediately wash it away with water. For your own safety, do not touch any part of the TV, the power cord and the antenna cable during lightning storms. For children's safety, do not leave children alone with the TV. [. . . ] (main power) on the TV to turn off the TV for about 15 minutes, then turn it on again to demagnetize the TV. TV cannot receive stereo broadcast sound or stereo broadcast sound switches on and off or is distorted. The 1 (standby) indicator on your TV flashes red several times after every three seconds. Count the number of times the 1 (standby) indicator flashes. contact your nearest Sony service center. The TV screen sometimes goes blank for slightly longer than usual during channel change. Some shooting games which involve pointing a light beam at the TV screen with an electronic gun or rifle cannot be used with your TV. For details, see the instruction manual supplied with the video game software. Changes in room temperature sometimes make the TV cabinet expand or contract, causing a noise. A small "boom" sound is heard when the TV is turned on. The visible lines that sometimes appear on your TV screen are shadows from the damper wires used to stabilize the aperture grille of the Trinitron picture tube. Buttons on the front panel can also be used for You are able to change the settings of your TV from "Settings" in WEGA GATE menu (see I). The following is an overview of the items that can be adjusted. Make sure the "Picture" icon ( ) is selected, then press . Choose either "100Hz" (reduce flicker on the screen to provide a stable picture) or "Progressive" (reduce jitter of any small areas or scanning lines on the screen). Press V or v to select "On", then press To cancel, select "Off", then press . "Intelligent Picture Signal Level" indicator will be displayed, followed by picture improvement when you change the program number or the input mode. Red amber green (weak) (average) (good) Press V or v to select "On", then press . "D-NR" (Digital Noise Reduction) Reduce noise level automatically to get optimum picture. * You can adjust the setting to your personal preference in the "Picture Adjustment" option only when the "Custom" mode is selected. ⷠ"Scan Mode" is not selectable when "Game Mode" is turned to "On". Press V or v to select either "Picture" (contrast), "Brightness", "Color", "Hue" (color tones), "Sharpness", "Color Temperature" (choose either "Cool", "Neutral" or "Warm") or "VM" (choose either "High", "Low" or . [. . . ] You can skip this program number when using PROG +/­. (3) To block unwanted program number, press V or v to select . (e) Repeat step (b) to (d) if you wish to change other channels. If you preset a blocked program number, that program number will be unblocked automatically. [. . . ]