User manual SONY KV-27FS16

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antennas. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. ATTENTION RISQUE DE CHOC ELECTRIQUE, NE PAS OUVRIR PRECAUCION RIESGO DE CHOQUE ELECTRICO NO ABRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Headphone jack is STEREO. Front A/V Panel 11 Using the Remote Control and Basic Functions This section shows you how to use the more advanced buttons on the remote control and how to use the on-screen menus. 1 2 3 qz qs qd qf 4 5 qg qh qj 6 7 qk ql 8 w; 9 wz 0 12 Using the Remote Control and Basic Functions Using the Remote Control 1 MUTING 2 SYSTEM OFF 3 TV/VCR 4 PICTURE MODE 5 SLEEP 6 JUMP Instantly turns off the sound. Press again or press to restore the sound. Powers off all Sony equipment at once (may not work with older equipment). Press when you are finished using a VCR and you want to switch to the TV Antenna input. Cycles through the available Video Mode settings. Turns the TV off automatically in approximately 15, 30, 45, 60 or 90 minutes. Cancel by pressing until SLEEP OFF appears. Press to jump back and forth between two channels. The TV alternates between current channel and the last channel that was selected. Press for a direct selection of Effect settings (Simulated, WOW, SRS, Off) (see page 20). Press to return to factory settings while in an on-screen menu. If no buttons are pressed, the menu closes automatically after about 90 seconds. 17 Using the Menus Using the Video To Display Menu To Select Video Mode : Vivid Picture Controls To access the Video menu, refer to the following steps: Move Select End Mode Customized picture viewing Vivid: Select for enhanced picture contrast and sharpness. Movie: Select for a finely detailed picture. Standard: Select for a standard picture. for direct Mode settings (Vivid, Movie, Sports, Standard). 18 Press Operating Instructions Picture Controls Menu To access the Picture Controls menu, first open the Video menu by referring to the following steps: To Display To Select Video : Vivid Picture Brightness Color Hue Sharpness Color Temp. : Cool VM : High Return Select Press f to highlight Picture Controls, then press g. Picture Controls End With the Picture Controls menu open: Picture: Press G to decrease the contrast. Brightness: Press G to darken the picture. Color: Press G to decrease color saturation. Sharpness: Press G to soften the picture. Use the F or f button to select from one of the following options: Cool: Gives the white colors a blue tint. Neutral: Gives the white colors a neutral tint. [. . . ] Check the TV/VIDEO settings: when watching TV, set to TV; when watching video equipment, set to VIDEO (page 13). Make sure the batteries have been inserted correctly into the remote control (page 2). Try another channel, it could be station trouble. Adjust Picture in the Picture Controls menu under Video (page 19). [. . . ]