User manual SONY KV-28CL10B

[. . . ] If any liquid leaks from the batteries and touches your skin, immediately wash it away with water. For your own safety, do not touch any part of the TV, the power cord and the antenna cable during lightning storms. For children's safety, do not leave children alone with the TV. To prevent fire or shock hazard, do not expose the TV to rain or moisture. [. . . ] Press (or SOUND MODE on the front panel) to select the desired sound mode. To listen to dynamic and clear sound that emphasizes both the low and high tones. Sound that emphasizes voice and high tones. The last adjusted sound setting from the "Sound Adjustment" option in the menu (see page 22). The WEGA Theatre Mode enables you to enjoy the best picture, sound and surround effect of a cinema from a DVD source. Place your TV and connected Sony equipment adjacent to each other so that you can control both the TV and the connected equipment by using the TV's remote control at the same time (see page 15). Select the proper video input from "WEGA Theatre Setup" menu and turn on (main power) the connected equipment (see page 26). If the connected equipment is a Sony audio/video equipment, you can set up the remote to work with the connected equipment (see page 15). to switch to WEGA Theatre Mode Press WEGA THEATRE. Be sure to aim the remote control at the TV set and connected equipment for about one second after the button is pressed. The connected equipment turns on automatically from standby mode and will start playing (only for Sony audio/video equipment). ⷠSome equipment might not respond properly to buttons on TV's remote. In this case, use the equipment's own remote control. How to use WEGA GATE (2) Press (or b) to confirm your selection or go to the next level. And V, v, B, b buttons on the front panel can also be used for the You are able to change the settings of your TV from "Settings" in WEGA GATE menu. The following is an overview of the items that can be adjusted. When a feature is dimmed in the menu, it is not selectable. The "Picture" menu allows you to adjust the picture settings. Make sure the "Picture" icon ( selected, then press . Choose either "DRC1250" (for high density pictures), "DRC100" (reduce flicker on the screen) or "Progressive" (reduce jitter of any small areas or scanning lines on the screen). Automatically, the picture will become clearer and sharper if the signal is good and noise will be reduced if the signal is noisy. Press V or v to select "On", then press To cancel, select "Off", then press . [. . . ] (2) Press V or v until the sound becomes normal, then press If you are not satisfied with the picture and sound quality, you may be able to improve them by using the "Fine" tuning feature. (3) Press V, v, B or b until the picture and sound quality are optimal, then press The + or ­ icon on the menu flashes while tuning. If the TV signal is too strong (picture distorted; picture with lines; signal interference) or weak (snowy picture), you may be able to improve the picture quality by setting the "Signal Booster" feature. (1) Press V or v to select "Signal Booster" , then press . [. . . ]