User manual SONY KV-28DX20U

[. . . ] This Instruction Manual has been produced using Totally chlorine free (TCF) 100% Re-cycled paper to comply with our commitment to the use of environmentally friendly materials in our products. A molded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. [. . . ] If you do not wish to store this channel on the programme number you selected, press the V or v buttons on the remote control to continue searching for the desired channel. If this is the channel you wish to store, press the OK button. Repeat steps 4-8 if you wish to store more channels then press the MENU button to remove the menu from the TV screen. NOTE: After manually tuning in the channels you require, you can sort the channels into the order you prefer by following the procedure `Re-arranging the TV channels' on page 11. This function enables you to skip unused programme positions when selecting them with the PROGR+/- buttons. However, by using the number buttons you can still select the skipped programme position. Press the v button on the remote control to select the symbol on the menu screen then press the b button to enter the `PRESET' menu. Press the v button to select `Manual Programme Preset' then press the b button to enter the `MANUAL PROGRAMME PRESET' menu. Press the V or v buttons to select the programme position you want to skip then press the b button to enter the `SYS' column. Repeat steps 4 and 5 to skip other programme positions. Names for channels are usually taken automatically from Teletext if available. You can however name a channel or an input video source using up to five characters (letters or numbers). Press the v button to select the symbol on the menu screen then press the b button to enter the `PRESET' menu. Press the v button to select `Manual Programme Preset' then press the b button to enter the `MANUAL PROGRAMME PRESET' menu. Press the b button repeatedly until the first element of the `LABEL' column is highlighted. Press the V or v buttons to select a letter or number (select `-' for a blank) then press the b button to confirm. Repeat steps 4 to 7 if you wish to label other channels. When viewing analogue channels press a numbered button on the remote control to select the channel which carries the teletext service you wish to receive. Press the button again if you wish to superimpose teletext on to the TV screen. If you make an error, complete the number, then reenter the correct page number. To move to the next or preceding page Press the or buttons to select the previous or next page. Using colour buttons to access pages (Fastext) When the colour coded menu appears at the bottom of a page, press the colour buttons (red, green, yellow or blue) on the control to access the corresponding page. [. . . ] â· Direct TV recording : While watching TV you need to press just one button on the VCR to record this programme. For more information on Smartlink please refer to your VCR instruction manual. This function enables you to designate a name to the optional equipment you have connected to the sockets of this TV. This name can be up to 5 characters (letters or numbers) and will appear on screen whenever the equipment is selected for use. [. . . ]