User manual SONY KV-28FQ70U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] To do this: after selecting the option press , then press or to set the time period delay (max. While watching the TV, you can press the button on the remote control to display the time remaining. â· One minute before the TV switches itself into standby mode, the time remaining is displayed on the TV screen automatically. Then press or to select On (if you wish the TV set to automatically switch the screen format according to the broadcast signal) or Off (if you wish to keep your preference). Even if you have selected "On" or "Off" in the "Auto Format" option, you can always modify the format of the screen by pressing repeatedly on the remote control to select one of the following formats: Smart: Imitation of wide screen effect for 4:3 broadcast. 4:3: 14:9: Conventional 4:3 picture size, full picture information. Compromise between 4:3 and 16:9 picture size. In "Smart", "Zoom" and "14:9" modes, parts of the top and bottom of the screen are cut off. AV PRESET The "AV Preset" option in the "Set Up" menu allows you to designate a name to the external equipment you have connected to the input sockets of this TV. To do this: 1 After selecting the option, press , then press or to select the input source you wish to name (AV1, AV2 and AV3 are for the rear Scarts and AV4 for front connectors). 2 A label automatically appears in the label column: a) If you want to use one of the 6 predefined label (CABLE, GAME, CAM, DVD, VIDEO or SAT), press or to select the desired label and finally press OK to store. B) If you want to set a different label, select Edit and press . Then with the first element highlighted, press or to select a letter, number or "-" for a blank, then press to confirm this character. Select the other four characters in the same way and finally press OK to store. One to the programme order of your choice. Press or to select which programme number you want to preset the channel on (for VCR, select programme number "0"). Then press the number buttons to enter directly the channel number of the TV Broadcast or the channel of the VCR signal. If you do not know the channel number, press or to search for it. When you have tuned the desired channel, press OK twice to store. Repeat all the above steps to tune and store more channels. Label a channel using up to five characters. To do this: Highlighting the Programme option, press the PROG +/- button to select the programme number with the channel you wish to name. [. . . ] â· Your brand codes may be lost if weak batteries are not replaced within a few minutes. To reset your brand of DVD or VCR please repeat the above steps. A small label is added inside the battery door to allow you to record your brand codes. â· Not all brands are covered and not all models of every brand may be covered. [. . . ]