User manual SONY KV-28FQ75U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 13 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 13 AMP FUSE, otherwise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] To set up the VCR: then press the OK button to download the information to your VCR. With this setting on you have the guaranteed recording of the whole broadcast should there be a change in the TV programme. This only works if the selected channel broadcasts a VPS/PDC signal. Speed Press V to select `Speed' the press the OK button repeatedly to select between `SP' for standard play or `LP' for longplay. With longplay you can record twice as much on a videotape. VCR Setup Press V to select `VCR Setup' then press the OK button repeatedly to select which VCR you wish to programme, namely `VCR1' or `VCR2'. Finally, press B to select the icon then press the OK button to remove the menu from the TV screen. The index page of the teletext service (usually page 100) gives you information on how to use the service. Please use a TV channel with a strong signal, otherwise there may be Teletext errors. Press b or B to select the first or second column. You can manually select which channel you wish to watch, either full-screen or in the PIP mode. Press the OK button again to display the selected channel or press mode from the TV screen. This PAP feature divides the screen into two for watching two channels simultaneously (with a video source on one if you want). The sound of the left screen comes through the TV loudspeakers, the sound of the right screen is selectable via headphones. Switching PAP on and off Press once to display the screens and twice to switch PAP off. Selecting sound for the headphones With PAP switched on, refer to the `Adjusting the picture and sound' section of this manual and set `i Dual Sound' to `PAP'. Zooming the screens Press the b or B buttons to change the size of the two screens. These displays will help you get the most from your TV, helping you to change picture and sound settings, to alter the size of the TV picture and to rearrange the TV channels etc. Adjusting the picture and sound The picture and sound are preset at the factory. You can however adjust them to suit your own taste. Press the v or V buttons to select for picture settings or for sound settings then press B to enter either the `Picture Adjustment' menu or the `Audio Adjustment' menu. Press the v or V buttons to select the item on the screen you wish to adjust then press B to confirm. [. . . ] Using the illustrations below, you can connect a wide range of audio and video equipment to your TV. To view the input signals of connected equipment, please follow the instructions below. Using the illustrations above, connect your equipment to the appropriate TV socket. Press the button repeatedly on the remote control until the correct input symbol for your equipment appears on the TV screen (see table below): Symbol on the TV screen Audio/video input signal through scart connector A or* RGB through scart connector A Audio/video input signal through scart connector B or* S-video through scart connector B Audio/video input signal through scart connector C or* S-video through scart connector C S-video input signal through the 4-pin DIN connector F or* video input signal through phono jack G and audio input signal through phono jacks H The picture from this equipment (if any are available) will appear on the TV screen. [. . . ]