User manual SONY KV-28FX201B

[. . . ] For environmental and safety reasons, it is recommended that the TV set is not left in standby mode when not in use. Never push objects of any kind into the set as this could result in a fire or electric shock. Never spill liquid of any kind on the set. If any liquid or solid object does fall into the cabinet, do not operate the TV. [. . . ] While watching the TV, you can press the button on the remote control to display the time remaining. ⷠOne minute before the TV switches itself into standby mode, the time remaining is displayed on the TV screen automatically. Then press or to select On (if you wish the TV set to automatically switch the screen format according to the broadcast signal) or Off (if you wish to keep your preference). Even if you have selected "On" or "Off" in the "Auto Format" option, you can always modify the format of the screen by pressing repeatedly on the remote control to select one of the following formats: Smart: Imitation of wide screen effect for 4:3 broadcast. 4:3: 14:9: Conventional 4:3 picture size, full picture information. Compromise between 4:3 and 16:9 picture size. In "Smart", "Zoom" and "14:9" modes, parts of the top and bottom of the screen are cut off. AV3 OUTPUT The "AV3 Output" option in the "Features" menu allows you to select the source to be output from the Scart connector 3/ S 3 so that you can record from this Scart any signal coming from the TV or from an external equipment connected to the Scart connectors 1/ 1 or 2/ 2 or side connectors S 4 or 4 and 4. If your VCR supports Smartlink, this procedure is not necessary. If you select "AUTO", the output signal will always be the same one that is displayed on the screen. If you have connected a decoder to the Scart 3/ S 3 or to a VCR connected to this Scart, please remember to change back the "AV3 Output" to "AUTO" or "TV" for correct unscrambling. to do this: after selecting the option , press . Then press or to correct any slant of the picture between -5 and +5. RGB CENTRING When connecting an RGB source, such as a "PlayStation", you may need to readjust the horizontal position of the picture. If this is the case, you can adjust it through the "RGB Centring" option in the "Detail Set Up". Then press or to adjust the centre of the picture between ­10 and +10. REMOTE CONTROL ID The "Remote Control ID" option in the "Detail Set Up" menu allows you to assign an ID to this TV remote control to avoid interference from other locators when you press the Remote Control button on the TV set. To do this: after selecting the option, press and then proceed in the same way as in the step 5 of the section "Switching On the TV and Automaticall Tuning" on page 8. The index page of the teletext service (usually page 100) gives you information on how to use the service. to operate teletext , use the remote control buttons as indicated below. Teletext errors may occur if you use a channel (TV Broadcast) with a weak signal. To switch on Teletext : After selecting the TV channel which carries the teletext service you wish to view, press . [. . . ] However, the distance may · (CENELEC Even within the signal standard) including reception area, there are audio / video input, S video some spots (dead spot) where input, selectable the RF signal can not be audio / video output and received. Design and specifications are subject to change without notice. Here are some simple solutions to problems which may affect the picture and sound. Using the menu system, select the "Picture Adjustment" menu and select "Reset" to return to the factory settings. [. . . ]