User manual SONY KV-28FX20B

[. . . ] ⷠTo avoid battery leakage and damage to the remote, remove the batteries from the remote if you are not going to use it for several days. If any liquid leaks from the batteries and touches your skin, immediately wash it away with water. For your own safety, do not touch any part of the TV, the power cord and the antenna cable during lightning storms. For children's safety, do not leave children alone with the TV. [. . . ] E) Repeat step b) to d) if you wish to change other channels. To prevent this "Initial Setup" menu from appearing again when you turn on the TV by pressing ! , press V or v to select "No" , then press . To allow this menu to appear again, select "Yes", then press . Initial Setup Display this menu next time?You can immediately go to the end of the "Initial Setup" menu by pressing WEGA GATE. Select sound mode options with a 5-Band Graphic Equalizer display. You can enjoy high quality sound by connecting the 3D WOOFER as follows: Connect only the supplied 3D WOOFER; otherwise your TV may malfunction. ⷠUnplug your TV from the wall outlet when connecting the 3D WOOFER. ⷠTo prevent a malfunction caused by a short circuit of the terminals, make sure that none of the 3D WOOFER wire strands stick out, making contact with the neighbouring 3D WOOFER terminal. If you connect a VCR to 8 (antenna input), preset the signal output from the VCR to the program number 0 on the TV (see O). * When the "Custom" mode is selected, you can receive the last adjusted sound settings from the "Sound Adjustment" option in the menu. * When the "Custom" mode is selected, you can receive the last adjusted picture settings from the "Picture Adjustment" option in the menu. Set TV to turn on automatically according to the desired period of time (max. The indicator on TV lights up amber once you set the wake up timer. If no buttons or controls are pressed for more than one hour after the TV is turned on using the wake up timer, the TV automatically goes into standby mode. Set TV to turn off automatically according to the desired period of time (max. , , , , , , (red, green, yellow, blue) How to use WEGA GATE (2) Press (or b) to confirm your selection or go to the next level. And V, v, B, b buttons on the top control panel can also be used for the You are able to change the settings of your TV from "Settings" in WEGA GATE menu. The following is an overview of the items that can be adjusted. When a feature is dimmed in the menu, it is not selectable. The "Picture" menu allows you to adjust the picture settings. [. . . ] Make sure that "Adjust" is selected, then press Selecting "Reset" will set your TV to the factory settings. Press B or b to select the desired sound frequency, then press V or v to adjust the setting and press . The adjusted settings will be received when you select "Custom". notes · Adjusting higher frequency will affect higher pitched sound and adjusting lower frequency will affect lower pitched sound. [. . . ]