User manual SONY KV-28FX65B

[. . . ] Address Mapping The position of the addresses in the OSDA is shown in the following diagram. the position values of the DPW are set to '0'. If other values are set, the complete combination will be scrolled. Address Mapping The position of the addresses in the OSDA is shown in the following diagram. [. . . ] With longplay you can record twice as much on a videotape. The picture quality, however, may suffer. Select with which of the connected Smartlink VCRs you wish programme. The index page of the teletext service (usually page 100) gives you information on how to use the service. Please use a TV channel with a strong signal, otherwise there may be Teletext errors. Select the TV channel which carries the teletext service you want to view. Press the button once to get Teletext only. Press a third time to switch off Teletext. Input three digits for the page number using the numbered buttons on the remote control. If you make a mistake, type in any three digits then re-enter the correct page number. Selecting the next or preceding page Press the or buttons on the remote control to select the previous or next page. Using colour buttons to access pages (Fastext) (only available if the TV station broadcasts Fastext signals) When the colour coded menu appears at the bottom of a page, press a coloured button on the remote control (green, red, yellow or blue) to access the corresponding page. Selecting a sub page A teletext page may consist of several sub pages. In this case an information line is displayed, showing the number of subpages. Press the numbered buttons on the remote control to select a teletext page which has several page numbers on it (eg the index page). Press v or V to select your chosen item on the screen then press B to display the relevant sub menu. Top/Bottom/Full The Top/Bottom/Full sub menu allows you to enlarge different sections of the Teletext page. Text Clear Text Clear is a function that displays a TV channel while a Teletext page is being searched for. Once the text page has been found a blue symbol will appear in the top left hand corner of the screen. Enter the desired page number using the numbered buttons on the remote control. Enter the desired time using the remote control. The TV will exit Teletext mode and the time will be displayed in the top left hand corner of the screen. [. . . ] Press the button repeatedly on the remote control until the correct input symbol for your equipment appears on the TV screen (see table below): Symbol on the TV screen Audio/video input signal through scart connector A or* RGB through scart connector A Audio/video input signal through scart connector B or* S-video through scart connector B Audio/video input signal through scart connector C or* S-video through scart connector C S-video input signal through the 4-pin DIN connector F or* video input signal through phono jack G and audio input signal through phono jacks H The picture from this equipment (if any are available) will appear on the TV screen. Note: To avoid picture distortion, do not connect equipment to the F and G sockets at the same time Connecting Headphones Plug in your headphones to the socket E on the front of the TV set. * * * * If the picture or sound is distorted, move the VCR away from the TV set. When connecting a monaural VCR, connect only the white jack to both the TV set and the VCR. [. . . ]