User manual SONY KV-28FX65E

[. . . ] Do not use benzine, thinner, or any other chemicals to clean the TV. Do not open the cabinet and the rear cover of the TV as high voltages and other hazards are present inside the TV. Your TV is recommended for home use only. Do not use the TV in any vehicle or where it may be subject to excessive dust, heat, moisture or vibrations. [. . . ] Do not use the TV in any vehicle or where it may be subject to excessive dust, heat, moisture or vibrations. Do not plug in too many appliances to the same power socket. Install the TV on a stable TV stand and floor which can support the TV set weight. Ensure that the TV stand surface is flat and its area is larger than the bottom area of the TV. Even if your TV is turned off, it is still connected to the AC power source (mains) as long as the power cord is plugged in. Unplug the TV before moving it or if you are not going to use it for several days. To prevent the TV from falling, use the supplied screws, clamps and band to secure the TV. Screw the band to the TV stand and to the provided hole at the rear of your TV. (2) Screw one clamp to a wall or pillar and the other clamp to the provided hole at the rear of your TV. * You can also use the 2 +/­ buttons on the TV to work as the +/­ buttons on the remote. The Sleep timer starts immediately after you have set it. notes · You can also cancel the Wake Up and Sleep timers by turning off the TV's main power. If no buttons or controls are pressed for more than two hours after the TV is turned on using the Wake Up timer, the TV automatically goes into standby mode. You can automatically preset up to 100 TV channels in numerical sequence from program number 1, or manually preset desired channels and channels that cannot be preset automatically. Presetting channels automatically from a specified program number 2 Press + or ­ once to enter the "AUTO PROGRAM" mode. the on-screen display will start flashing. Press PROGR +/­ or the number buttons 3 the desired program number appears onuntil the screen. Press PROGR +/­ or the number buttons 3 the desired program number appears onuntil the screen. Other channels manually, repeat steps If the color is abnormal when receiving programs through the 8 (antenna input) terminal or the t (video input) terminal (1) Press SELECT until "COLOR SYS" appears on the screen. (1) Press PROGR +/­ or the number buttons until the unused or unwanted program number appears on the screen. [. . . ] Other channels manually, repeat steps If the color is abnormal when receiving programs through the 8 (antenna input) terminal or the t (video input) terminal (1) Press SELECT until "COLOR SYS" appears on the screen. (1) Press PROGR +/­ or the number buttons until the unused or unwanted program number appears on the screen. (2) Press SELECT until "MANUAL PROGRAM" appears on the screen. (3) Press + or ­ once to enter the "MANUAL PROGRAM" mode. [. . . ]