User manual SONY KV-28LS35E

[. . . ] Do not use benzine, thinner, or any other chemicals to clean the TV. Do not open the cabinet and the rear cover of the TV as high voltages and other hazards are present inside the TV. Your TV is recommended for home use only. Do not use the TV in any vehicle or where it may be subject to excessive dust, heat, moisture or vibrations. [. . . ] Unplug the TV before moving it or if you are not going to use it for several days. To prevent the TV from falling, use the supplied screws, clamps and band to secure the TV. Screw the band to the TV stand and to the provided hole at the rear of your TV. (2) Screw one clamp to a wall or pillar and the other clamp to the provided hole at the rear of your TV. * You can also use the 2 +/­ buttons on the TV to work as the +/­ buttons on the remote. Do not connect video equipment to t (video input) at the front and the rear of your TV at the same time; otherwise the picture will not be displayed properly on the screen. If you find any problem while viewing your TV, please check the following guide. If any problem persists, contact your Sony dealer. symptom Snowy picture, noisy sound Press A/B until the sound is optimal. Do not use a hair dryer or other equipment near the TV. Keep external speakers or other electrical equipment away from the TV. Other channels manually, repeat steps 3 If the picture or sound is abnormal when receiving programs through the 8 (antenna input) terminal (1) Press SELECT until "TV SYS" appears on the screen. (2) Press + or ­ to select the appropriate TV system until the picture or sound quality is optimal. If the color is abnormal when receiving programs through the 8 (antenna input) terminal or the t (video input) terminal (1) Press SELECT until "COLOR SYS" appears on the screen. (1) Press PROGR +/­ or the number buttons until the unused or unwanted program number appears on the screen. (2) Press SELECT until "MANUAL PROGRAM" appears on the screen. (3) Press + or ­ once to enter the "MANUAL PROGRAM" mode. The fine tuning (FINE) function may help to reduce the following problems: double images and lines moving across the TV screen. You can use the fine tuning function as below: (1) Select the program number you want to adjust. (2) Press SELECT until "MANUAL PROGRAM" appears on the screen. (3) Press + or ­ once to enter the "MANUAL PROGRAM" mode. (4) Press to display "FINE" on the screen. [. . . ] Select "9 DYNAMIC" To listen to dynamic and clear sound that emphasizes the low and high sound. Adjusting the picture and sound settings Each time you press SELECT, the setting item will change as follows: To adjust other items, repeat steps 1 to 2. Reducing "SHARP" can also reduce picture noise. If the picture is slanting, you can adjust the picture position using the "PIC ROTATION" function until it is optimal. [. . . ]