User manual SONY KV-28LS60B

[. . . ] Do not use the TV in any vehicle or where it may be subject to excessive dust, heat, moisture or vibrations. Do not plug in too many appliances to the same power socket. Do not open the cabinet and the rear cover of the TV as high voltages and other hazards are present inside the TV. Do not use benzine, thinner, or any other chemicals to clean the TV. [. . . ] Jump to last program number that has been watched for at least five seconds. To select quickly, press and hold until the desired program number appears. For program numbers 10 and above, enter the second digit within two seconds. select picture mode options: "Vivid" , "Standard" , "Custom"* (see page 10). * When the "Custom" mode is selected, you can receive the last adjusted picture settings from the "Picture Adjustment" option in the menu. Set TV to turn on automatically according to the desired period of time (Wake Up Timer) (max. The indicator on TV lights up amber once you set the wake up timer. If no buttons or controls are pressed for more than one hour after the TV is turned on using the wake up timer, the TV automatically goes into standby mode. Set TV to turn off automatically according to the desired period of time (max. If there is no Teletext broadcast, only "100" is displayed at the top left corner of the screen. Enter the Teletext page number that you want to refer to, then press . Press b until the mode that you wish to edit is highlighted: Label, Skip, (block symbol). You can skip this program number when using PROG +/­. (3) To block unwanted program number, press V or v to select . (e) Repeat step (b) to (d) if you wish to change other channels. If you preset a blocked program number, that program number will be unblocked automatically. ⷠIf you sort a blocked program, that program will remain blocked. After selecting "Manual Program", select the program number to which you want to preset a channel. (1) Make sure "Program" is selected, then press (2) Press V or v until the program number you want to preset appears on the menu, then press . (1) Make sure either "VHF Low", "VHF High" or "UHF" is selected, then press . (2) Press V or v until the desired channel's broadcast appears on the TV screen, then press . (2) Press V or v until the sound becomes normal, then press If you are not satisfied with the picture and sound quality, you may be able to improve them by using the "Fine" tuning feature. [. . . ] Keep external speakers or other electrical equipment away from the TV. Keep external speakers or other equipment away from the TV. Do not move the TV while the TV is turned on. Press 1 (main power) on the TV to turn off the TV for about 15 minutes, then turn it on again to demagnetize the TV. [. . . ]