User manual SONY KV-28LS60E

[. . . ] â· To avoid battery leakage and damage to the remote, remove the batteries from the remote if you are not going to use it for several days. If any liquid leaks from the batteries and touches your skin, immediately wash it away with water. For your own safety, do not touch any part of the TV, the power cord and the antenna cable during lightning storms. For children's safety, do not leave children alone with the TV. [. . . ] The 1 (standby) indicator on your TV flashes red several times after every three seconds. Count the number of times the 1 (standby) indicator flashes. Press 1 on the TV to turn it off, disconnect the AC power cord and inform your dealer or Sony service center of how the indicator flashes (duration and interval). The TV screen sometimes goes blank for slightly longer than usual during channel change. Changes in room temperature sometimes make the TV cabinet expand or contract, causing a noise. A small "boom" sound is heard when the TV is turned on. Jump to last program number that has been watched for at least five seconds. To select quickly, press and hold until the desired program number appears. If the stereo sound is noisy when receiving a stereo program, select "Mono". The sound becomes monaural, but the noise is reduced. For program numbers 10 and above, enter the second digit within two seconds. How to use WEGA GATE (or b) to confirm your selection (2) Press or go to the next level. When a feature is dimmed in the menu, it is not selectable. â· The WEGA GATE, and , , , buttons on the front panel can also be used for the operations above. Make sure the "Picture" icon ( ) is selected, then press . Press V or v to select "On", then press To cancel, select "Off", then press . "Intelligent Picture Signal Level" indicator will be displayed, followed by picture improvement when you change the program number or the input mode. Press V or v to select "On", then press To cancel, select "Off", then press . "Intelligent Picture" is still functioning. * You can adjust the setting to your personal preference in the "Picture Adjustment" and "Color Temperature" options only when the "Custom" mode is selected. Press V or v to select either "Picture" (contrast), "Brightness", "Color", "Hue" (color tones) or "Sharpness", then press . Selecting "Reset" will set your TV to the factory settings. [. . . ] Searching stops automatically when a station is tuned in. If the station has a noisy sound, you may be able to improve the sound quality by pressing B or b. (4) Repeat steps (1) through (3) to preset other FM radio stations. * The "FM Radio Setup" feature is only available in FM Radio mode. [. . . ]