User manual SONY KV-29FX20U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] However, if you need to change the language menu afterwards, select the menu LANGUAGE in the and proceed in the same way as described below. Press the on/off button on your TV set to switch on your TV. The first time you press the on/off button on your TV set, the language menu displays automatically on the TV screen. Press the or button on the remote control to select the language, then press the OK button to confirm your selection. By following the instructions below, this TV automatically searches and stores all available channels for you. After having selected the language, a new menu appears automatically on the TV screen asking you to automatically tune the TV. However, if you need to change or repeat the tuning afterwards (e. When you move house), select the menu AUTO PROGRAMME in the (SET UP) menu and proceed in the same way as described below in step 1 or, please refer to the section "Automatically Tuning the TV using the TV buttons" of this instruction manual. A new menu appears automatically on the screen asking you to check that the antenna is connected. When the automatic tuning is finished, the Programme Sorting menu appears on the TV screen. If you stop the automatic tuning by pressing the MENU button, the Programme Sorting menu does not appear automatically on the TV screen. After all available channels (TV Broadcast) are captioned and stored, a new menu appears automatically on the screen to change the order in which the channels appear on the screen. However, if you wish to rearrange the order of the channels afterwards, select the menu PROGRAMME SORTING in the (SET UP) menu and proceed in the same way as described in the b) section of this chapter. A) If you do not wish to change the channel order: Your TV is now ready for use. Press the PROGR or button until the channel (TV Broadcast) you wish to rearrange appears on the screen. Press the or button to select the new programme number position for your selected channel (TV Broadcast), then press the OK button. The word CONFIRM is highlighted for a few seconds to confirm that the new programme position is stored. Repeat steps 1 and 2 if you wish to change the order of the other channels on your TV. Besides the explanation in the section "Automatically Tuning the TV using the Remote Control", by following the instructions below, this TV also searches and stores automatically all available channels using just one button of the TV set. Press the flap on the front of the TV by pressing on the reveal the front control panel. [. . . ] Press the button to select your desired picture mode (PERSONAL, LIVE or MOVIE). Although the sound is adjusted at the factory, you can modify it to suit your own taste. Press the button to select the symbol, then press the to enter to the SOUND CONTROL menu. With the cursor highlighting the item you wish to change, press the button. [. . . ]