User manual SONY KV-29FX30E

[. . . ] Do not install the unit in hot, humid, or excessively dusty places. Do not install the unit where it may be exposed to mechanical vibrations. This video TV is designed to receive TV programmes based on PAL (B/G and D/K) and SECAM (B/G and D/K) colour systems and to record and play on PAL and MESECAM colour systems. Do not operate the unit on anything but 230 V AC. [. . . ] This section explains the basic functions you use while watching the TV. Most of the operations can be done using the Remote Commander. The video TV enters standby mode and the u lamp on the front of the video TV lights up in red. To switch off the main power Disconnect the mains lead from a wall outlet. To select a double-digit number using the number buttons For example, if you want to choose 14, press ÷ To resume normal sound, press ¤ again or Á +. To have the programme number and caption stay on the screen, press e again. To make the indications disappear, press e until no indications are displayed on the screen. You can select one of four settings for picture effect in the menu. You can also adjust the picture to suit your own taste. Setting PICTURE CONTROL STANDARD MILD MOVIE Picture effect The adjusted picture control levels are stored. When watching a movie With each press the vertical bars increase or decrease and the figure at the right margin changes to show the control level. The tape counter helps you to locate a certain scene after playback. The video TV keeps counting the length of the tape being played. Note, however, that the tape counter does not count the portions without video signals recorded. Note The tape operation mode will be displayed whenever you change the mode (even when the e is turned off. 3 Select the programme position with PROGR+/­. You can also use number The REC lamp on the front of the video TV lights up and recording begins. When the tape reaches the end, the video TV rewinds the tape automatically to the beginning, then stops. This function does not work when the power of the video TV is off. You can cut out an unwanted scene during recording with this button. 1 Press PAUSE P when an unwanted scene appears on the screen. 2 Press PAUSE P again to release the pause mode at the desired scene. [. . . ] Each press the time period changes as follows: 0:00 To change the recording time period after quick-timer recording begins Press QUICK TIMER until the desired time period appears. Even if you switch off the video TV, it continues recording. When the preset time period has elapsed, the video TV stops recording. You can automatically switches the video TV into standby mode after a selected time period. [. . . ]