User manual SONY KV-32CS70U

[. . . ] Before operating the TV, please read the "Safety Information" section of this manual. Retain this manual for future reference. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. [. . . ] Resets the sound to the factory preset levels. V Off: volume level changes according to the broadcast signal. V On: volume level of the channels will stay the same, independent of the broadcast signal (e. If you are listening to the TV through headphones, the "Effect" option is automatically switched to "Off". ** This TV has been designed to create the "Dolby Surround" sound effect by simulating the sound of four speakers with only two speakers, when the broadcast audio signal is Dolby Surround encoded. The sound effect can also be improved by connecting a suitable external amplifier (for details refer to "Connecting to external audio Equipment" on page 19). The "Sleep Timer" option in the "Timer" menu allows you to select a time period for the TV to automatically switch itself into the standby mode. To do this: After selecting the option, press the b button then press the v or V button to set the time period delay (max. While watching the TV, you can press the button on the remote control to display the time remaining. â· One minute before the TV switches itself into standby mode, the time remaining is displayed on the TV screen automatically. The "Language" option in the "Set Up" menu allows you to select the language in which the menus are displayed. To do this: After selecting the option, press the b button then proceed in the same way as in step 2 of the section "Switching On the TV and Automatically Tuning" on page 7. The "Auto Tuning" option in the "Set Up" menu allows you to automatically search for and store all available TV channels. To do this: After selecting the option, press the b button then proceed in the same way as in TV steps 4 and 5 of the section "Switching On the TV and Automatically Tuning" on page 7 and 8. The "Programme Sorting" option in the "Set Up" menu allows you to change the order in which the channels (TV Broadcasts) appear on the screen. To do this: After selecting the option, press the b button then proceed in the same way as in step 6 b) of the section "Switching On the TV and Automatically Tuning" on page 8. Repeat all the above steps to tune and store more channels. B) Label a channel using up to five characters. To do this: After highlighting the Programme option, press the PROG +/- button to select the programme number of the channel you wish to name. When the programme you want to name appears on the screen, select the Label option and press b button. Next press the v or V buttons to select a letter, number or "-" for a blank. After selecting all the characters, press the OK button twice to store. [. . . ] If Media Selector is set to TV position, the code numbers will not be stored Before the green light goes out, press and hold the yellow button for approximately 6 seconds until the green light starts flashing. Whilst the green light is flashing, enter all three digits of the code allocated to your brand of VCR or DVD using the number buttons on the remote control. If your selected code is entered correctly, all three green lights will be lit momentarily. Turn on your VCR or DVD and check that the main functions work. [. . . ]