User manual SONY KV-32DS20U

[. . . ] This Instruction Manual has been produced using Totally chlorine free (TCF) 100% Re-cycled paper to comply with our commitment to the use of environmentally friendly materials in our products. A molded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. [. . . ] The symbol appears before the programme position to indicate this channel is now blocked. Repeat step 4 if you wish to block other channels. Using the sleep timer The TV can be set to switch automatically to standby mode after a length of time chosen by you. To return to normal operation from standby mode, press the / button. You have already tuned the TV automatically using the instructions at the start of this manual. You can however carry out this operation manually, adding channels to the TV, one at a time. Press the v button to select the symbol on the TV screen then press the b button to enter the PRESET menu. Press the v button to select `Manual Programme Preset' on the menu screen then press the b button to enter the `MANUAL PROGRAMME PRESET' menu. Press the V or v buttons to select an unused programme number for your channel then press the b button to enter. Select the first number digit of `CHAN' (channel) then the second number digit of `CHAN' with the number buttons on the remote control or Press the V or v buttons to search for the next available channel. If you wish to change the `SERV' service number, select each digit in turn and press the numbered buttons on the remote control to change to your desired service 8. If you do not wish to store this channel on the programme number you selected, press the V or v buttons on the remote control to continue searching for the desired channel. If this is the channel you wish to store, press the OK button. Repeat steps 4-8 if you wish to store more channels then press the MENU button to remove the menu from the TV screen. NOTE: After manually tuning in the channels you require, you can sort the channels into the order you prefer by following the procedure `Re-arranging the TV channels' on page 13. This function enables you to skip unused programme positions when selecting them with the PROGR+/- buttons. However, by using the number buttons you can still select the skipped programme position. Press the v button on the remote control to select the symbol on the menu screen then press the b button to enter the `PRESET' menu. Press the v button to select `Manual Programme Preset' then press the b button to enter the `MANUAL PROGRAMME PRESET' menu. Press the V or v buttons to select the programme position you want to skip then press the b button to enter the `SYS' column. Repeat steps 4 and 5 to skip other programme positions. Names for channels are usually taken automatically from Teletext if available. [. . . ] â· Direct TV recording : While watching TV you need to press just one button on the VCR to record this programme. For more information on Smartlink please refer to your VCR instruction manual. This function enables you to designate a name to the optional equipment you have connected to the sockets of this TV. This name can be up to 5 characters (letters or numbers) and will appear on screen whenever the equipment is selected for use. [. . . ]