User manual SONY KV-32FC60Z

[. . . ] NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] 1 2a b 3 Select the TV channel which carries the teletext service you want to view. Button once on your remote control to switch Teletext on. Input the three digits of the page number using the number buttons on your remote control. If you have made a mistake: Type in any three digits, then re-enter the correct page number. Page Catching 1 Using the number buttons on the remote control, select a teletext page which has several page numbers on it (e. Select the desired page number using 4 or $ then press the OK button. A teletext page may consist of several subpages. In this case an information line is displayed, showing the number of subpages. *depending on availability of service Fastext lets you access pages with one button stroke. When Fastext is broadcast, a colour-coded menu appears at the bottom of the screen. The colours of this menu correspond to the red, green, yellow and blue buttons on the remote control. When teletext is switched on you can use the joystick buttons to operate the teletext menu. For convenient reading of a Teletext page you can enlarge it. Push to 4 to enlarge the upper half of the screen, push to $ to enlarge the lower half. After having selected the function, you can watch a TV channel while waiting for a requested Teletext page. As soon as the page is available, the symbol changes colour. Enter the three digits of the desired page using the number buttons. Enter the four digits of the desired time using the number buttons. These displays will help you get the most from your TV, helping you to change picture and sound settings, to alter the size of the TV picture and to rearrange the TV channels etc. Adjusting the picture and sound Picture and sound are adjusted at the factory. You can however, adjust them individually. You can select the source to be output from the Scart connector Y2/j2. [. . . ] Om du inte ska ansluta en video till tv:n, anslut antennsladd(se bildentill vänster) och fortsätt till avsnitt 4. Slå av till standby-läge Tryck för att slå av tv:n till standby-läge. Atergå till den senast sedda kanalen Tryck för att återgå till den kanal du senast tittade på. Aterställning till fabriksinställning Oppna luckan och tryck på knappen för att återställa bild och ljud till fabriksinställning. [. . . ]