User manual SONY KV-32FX20E

[. . . ] For environmental and safety reasons, it is recommended that the TV set is not left in standby mode when not in use. Never push objects of any kind into the set as this could result in a fire or electric shock. Never spill liquid of any kind on the set. If any liquid or solid object does fall through, do not operate the TV. [. . . ] Enhances clarity, detail and presence of sound by using "BBE High Definition Sound system"*. Dynamic: "BBE High Definition Sound system"* intensifies clarity and presence of sound for better intelligibility and musical realism. Less More Less More Left Right Resets the sound to the factory preset levels. Off: Volume level changes according to the broadcast signal. On: Volume level of the channels will stay the same, independent of the broadcast signal (e. If you are listening to the TV through headphones, the "Effect" option will automatically be switched to "Off". ** This TV has been designed to create the "Dolby Surround" sound effect by simulating the sound of four speakers with two speakers, when the broadcast audio signal is Dolby Surround encoded. The sound effect can also be improved by connecting a suitable external amplifier (for details refer to "Connecting to external audio Equipment" on page 18). SLEEP TIMER The "Sleep Timer" option in the "Timer" menu allows you to select a time period for the TV to switch itself automatically into the standby mode. To do this: after selecting the option press , then press or to set the time period delay (max. While watching the TV, you can press the button on the remote control to display the time remaining. When you tune the desired channel, press OK twice to store. Repeat all the above steps to tune and store more channels. Label a channel using up to five characters. To do this: Highlighting the Programme option, press the PROG +/- button to select the programme number with the channel you wish to name. When the programme you want to name appears on the screen, select the Label option and press . Next press or to select a letter, number or "-" for a blank. After selecting all the characters, press OK twice to store. Normally the automatic fine tuning (AFT) will give the best possible picture, however you can manually fine tune the TV to obtain a better picture reception in case the picture is distorted. To do this: while watching the channel (TV Broadcast) you wish to fine tune, select the AFT option and press . Next press or to adjust the fine tuning between -15 and +15. Skip any unwanted programme numbers when they are selected with the PROG +/- buttons. [. . . ] If Media Selector is on TV position, code numbers will not be stored. Before the green light goes out, press and hold the yellow button for approximately 6 seconds until the green light starts flashing. Whilst the green light is flashing, enter all three digits of the code for your brand of VCR or DVD using the number buttons on the remote control. If your selected code is entered correctly, all three green lights will be lit momentarily. [. . . ]