User manual SONY KV-36FQ80K

[. . . ] Address Mapping The position of the addresses in the OSDA is shown in the following diagram. the position values of the DPW are set to '0'. If other values are set, the complete combination will be scrolled. Address Mapping The position of the addresses in the OSDA is shown in the following diagram. [. . . ] How to use Equaliser Adjustment This option allows you to customise the sound by adjusting five frequency bands. Note: This feature is only available when Sound Effect is set to Personal. Virtual Effect This option allows you to adjust the level of the surround sound effect when listening to a Dolby surround sound broadcast. Note: This option is only available when Sound Effect is set to Dolby V. Balance This option allows you to set the balance of sound between the left and right speakers. This option allows you to cancel this effect, giving a constant volume level. Dual Sound When receiving a bilingual broadcast: This option allows you to choose which language to listen to. When receiving a bilingual broadcast: Press V or v to select A to listen to the first language or B to listen to the second language. When receiving a stereo broadcast: This option allows you to choose between mono or stereo sound. This option allows you to simultaneously set the volume level for the headphone socket and the volume level of the Audio output sockets on the rear of the TV. Dual Sound This option allows you to alter the sound settings when the TV is in PAP mode. The settings available are: Stereo: The sound from one screen is output to both the TV loudspeakers and the headphones. PAP: The sound from the left screen is output to the TV loudspeakers and the sound from the right screen is output to the headphones. Notes: * When `Dolby V' is selected, the TV simulates the full effects of Dolby Pro Logic Surround sound without the need for additional speakers. This system enhances clarity, detail, presence of sound and increases musical realism. This menu allows you to set the sleep timer and to set a signal to be output from the AV3 socket. The table below explains each option and how to use it: Auto Format With this option switched on, the TV can automatically adjust the picture size to suit the broadcast. When viewing 4:3 or 14:9 broadcasts there will be dark areas visible at the edge of the screen. Sleep Timer This option allows you to set a period of time after which the TV switches itself into standby mode. this can be in 10 minute intervals up to a maximum of 90 minutes. AV3 Output This option allows you to set which signal source is output from the AV3 scart socket (labelled 3/ s 3 ) on the rear of the TV. If you connect a VCR to this socket you can record from equipment connected to the other sockets of the TV. [. . . ] Poor or no picture (screen is dark), but good sound. From the Picture Adjustment menu select RESET to return to the factory settings. turn off any equipment connected to the scart connectors on the rear of the TV. Check that the b MODE B Selector button on the remote control is set according to the device you are using (VCR, DVD or TV). [. . . ]