User manual SONY KV-BZ212M71

[. . . ] Your TV is recommended for home use only. Do not use the TV in any vehicle or where it may be subject to excessive dust, heat, moisture or vibrations. Do not plug in too many appliances to the same power socket. Do not open the cabinet and the rear cover of the TV as high voltages and other hazards are present inside the TV. [. . . ] You can connect the audio L and R terminals from your AV equipment to both (MONO) terminals on the TV to enjoy mixed left and right sound. If you do not prefer the mixed sound, disconnect either one of the (MONO) terminals. If you connect a VCR to 8 (antenna input), preset the signal output from the VCR to the program number 0 on the TV (see K). Jump to last program number that has been watched for at least five seconds. To select quickly, press and hold until the desired program number appears. For program numbers 10 and above, enter the second digit within two seconds. select picture mode options: "Vivid" , "Standard" , "Custom"* (see I). * When the "Custom" mode is selected, you can receive the last adjusted picture settings from the "Picture Adjustment" option in the menu. Set TV to turn on automatically according to the desired period of time (Wake Up Timer) (max. The indicator on TV lights up amber once you set the wake up timer. If no buttons or controls are pressed for more than three hours after the TV is turned on using the wake up timer, the TV automatically goes into standby mode. Make sure the "Picture" icon ( ) is selected, then press . Press V or v to select "On", then press To cancel, select "Off", then press . "Intelligent Picture Signal Level" indicator will be displayed, followed by picture improvement when you change the program number or the input mode. * You can adjust the setting to your personal preference in the "Picture Adjustment" and "Color Temperature" options only when the "Custom" mode is selected. Press V or v to select either "Picture" (contrast), "Brightness", "Color", "Hue" (color tones) or "Sharpness", then press . Selecting "Reset" will set your TV to the factory settings. Press V, v, B or b to adjust the setting of your selected item, then press Repeat the above steps to adjust other items. The adjusted settings will be received when you select "Custom". Reducing "Sharpness" can also reduce picture noise. (a) If you wish to keep the channels in the current condition, press WEGA GATE to exit. (b) Press V or v to select the program number with the channel you wish to change. [. . . ] (2) Press V or v until the program number you want to preset appears on the menu, then press . (1) Make sure either "VHF Low", "VHF High" or "UHF" is selected, then press . (2) Press V or v until the desired channel's broadcast appears on the TV screen, then press . (2) Press V or v until the sound becomes normal, then press If you are not satisfied with the picture and sound quality, you may be able to improve them by using the "Fine" tuning feature. [. . . ]