User manual SONY KV-BZ213M70

[. . . ] Do not operate the TV if any liquid or solid object falls into it. Install the TV on a stable TV stand and floor which can support the TV set weight. Ensure that the TV stand surface is flat and its area is larger than the bottom area of the TV. Do not install the TV in a confined space, such as a bookcase or built-in cabinet. [. . . ] Set TV to turn off automatically according to the desired period of time (max. (red, green, yellow, blue) PIP operations , , V, v, B, b Not function for your TV. If you find any problem while viewing your TV, you can either use the "Factory Settings" function (see L) or check the Troubleshooting guide below. if the problem persists , contact your Sony dealer. Snowy picture, noisy sound Distorted picture, noisy sound Set the "Signal Booster" to "Off" (see K), or turn off or disconnect any external booster in use. Good picture, noisy sound No picture, no sound Check the power cord, antenna setup and other connections. (main power) on the TV to turn off the TV for about five seconds, then turn it on again. Good picture, no sound Do not use a hair dryer or other equipment near the TV. Turn off or disconnect any external booster in use. Keep external speakers or other electrical equipment away from the TV. Keep external speakers or other equipment away from the TV. Do not move the TV while the TV is turned on. (main power) on the TV to turn off the TV for about 15 minutes, then turn it on again to demagnetize the TV. The 1 (standby) indicator on your TV flashes red several times after every three seconds. Count the number of times the 1 (standby) indicator flashes. contact your nearest Sony service center. The TV screen sometimes goes blank for slightly longer than usual during channel change. Changes in room temperature sometimes make the TV cabinet expand or contract, causing a noise. A small "boom" sound is heard when the TV is turned on. How to use WEGA GATE (2) Press (or b) to confirm your selection or go to the next level. When a feature is dimmed in the menu, it is not selectable. ⷠThe WEGA GATE, and V, v, B, b buttons on the top control panel can also be used for the operations above. [. . . ] (3) Press V, v, B or b until the picture and sound quality are optimal, then press The + or ­ icon on the menu flashes while tuning. If the TV signal is too strong (picture distorted; picture with lines; signal interference) or weak (snowy picture), you may be able to improve the picture quality by setting the "Signal Booster" feature. (1) Press V or v to select "Signal Booster" , then press . (2) Press V or v to select either "Off" (for picture distorted; picture with lines; signal interference) or "Auto" (for snowy picture), then press . [. . . ]