User manual SONY KV-SW21M80

[. . . ] Before operating the unit, please read this manual thoroughly and retain it for future reference. I (Headphone) Picture tube Tube size (cm) Screen size (cm) Dimensions (w/h/d, mm) Mass (kg) Design and specifications are subject to change without notice. Dangerously high voltages are present inside the TV. Do not plug in the power cord until you have completed making all other connections; otherwise a minimum leakage current might flow through the antenna and other terminals to ground. [. . . ] If your DVD player can output interlace and progressive mode signals, select the interlace (component video input) on your TV. Your TV can receive output when connecting to either 525i/60Hz or 625i/50Hz interlace signals. â· The component video terminals on your DVD player are sometimes labeled Y/CB/CR, Y/PB/ PR, Y/Cb/Cr or Y/B-Y/R-Y. â· If you select "DVD" on your TV screen, the signal from the T (monitor output) jacks will not be output properly. If you find any problem while viewing your TV, you can either use the "Factory Settings" function or check the Troubleshooting guide below. Your TV will go blank for a few seconds, then the "Initial Setup" menu will appear. Your TV will be set to factory settings, but certain problems may be solved. symptom Snowy picture, noisy sound (main power) on the TV to turn off the TV for about five seconds, then turn it on again (see F). Distorted picture, noisy sound Good picture, noisy sound No picture, no sound Good picture, no sound Dotted lines or stripes Double images or "ghosts" Do not use a hair dryer or other equipment near the TV. Display the "Picture" menu and select "Custom" from "Picture Mode", then adjust the "Color" level from "Picture Adjustment" (see M). Keep external speakers or other electrical equipment away from the TV. â· Keep external speakers or other equipment away from the TV. Do not move the TV while the TV is turned on. (main power) on the TV to turn off the TV for about 15 minutes, then turn it on again to demagnetize the TV. â· Count the number of times the 1 (standby) indicator flashes. The 1 (standby) indicator on your TV flashes red several times after every three seconds. The TV screen sometimes goes blank for slightly longer than usual during channel change. Changes in room temperature sometimes make the TV cabinet expand or contract, causing a noise. A small "boom" sound is heard when the TV is turned on. /1 Description Turn off temporarily or turn on the TV. Jump to last program number that has been watched for at least five seconds. Select sound mode options with a 5-Band Graphic Equalizer display: "Dynamic", "Standard", "Custom"*. [. . . ] â· You may display the settings directly using the SOUND MODE button on the top control panel (see F) or button on the remote control (see J). Change the order in which the channels appear on the screen, label the program number, skip the program number and block unwanted programs. If you preset a blocked program number, that program number will be unblocked automatically. â· If you sort a blocked program, that program will remain blocked. [. . . ]