User manual SONY KV-SZ252M91

[. . . ] Before operating the unit, please read this manual thoroughly and retain it for future reference. I (Headphone) FM Radio Tuning Range Intermediate Frequency Picture tube Tube size (cm) Screen size (cm) Dimensions (w/h/d) Mass (kg) Design and specifications are subject to change without notice. Dangerously high voltages are present inside the TV. Do not plug in the power cord until you have completed making all other connections; otherwise a minimum leakage current might flow through the antenna and other terminals to ground. [. . . ] If no buttons or controls are pressed for more than three hours after the TV is turned on using the wake up timer, the TV automatically goes into standby mode. (Sleep Timer) Set TV to turn off automatically according to the desired period of time (max. If there is no Teletext broadcast, only "100" is displayed at the top left corner of the screen. Enter the Teletext page number that you want to refer to, then press . When the page number is displayed, press to show the text. (red , green , Access the corresponding colored FASTEXT menu. The FASTEXT yellow, blue) feature can be used only when the FASTEXT broadcast is available. You are able to listen to the FM radio stations using your TV by connecting an antenna (see F). To exit from FM Radio mode: Press WEGA GATE button, select the desired items: "TV" or "External Inputs", then press . You can also use the 1-9 buttons on the remote control to directly select the desired preset FM radio station. The preset number and label will not be displayed. â· You can only operate V, v, B and b functions using the remote control buttons in FM Radio mode. â· The available radio frequency is only for temporary listening pleasure and cannot be stored in the memory. If the station has a noisy sound, you may be able to improve the sound quality by pressing B or b. â· When a FM stereo program has static noise, press A/B until "Mono" appears. There will be no stereo effect, but the noise will be reduced. If you find any problem while viewing your TV, you can either use the "Factory Settings" function (see N) or check the Troubleshooting guide below. if the problem persists , contact your Sony dealer. Snowy picture, noisy sound Distorted picture, noisy sound Set the "Signal Booster" to "Off" (see M), or turn off or disconnect any external booster in use. Good picture, noisy sound No picture, no sound Check the power cord, antenna setup and other connections. Press 1 (main power) on the TV to turn off the TV for about five seconds, then turn it on again. Good picture, no sound Do not use a hair dryer or other equipment near the TV. [. . . ] â· Adjusting higher frequency will affect higher pitched sound and adjusting lower frequency will affect lower pitched sound. â· You may display the settings directly by using the button on the remote control (see G). (a) If you wish to keep the channels in the current condition, press WEGA GATE to exit. (b) Press V or v to select the program number with the channel you wish to change. [. . . ]