User manual SONY KV-XF21M80

[. . . ] The features you will enjoy include: · FAVORITE CH for quick and easy channel selection (page 16) · PICTURE MODE/SOUND MODE/SURROUND for customizing your TV (pages 14, 15) Your TV also offers the following setup features: · You are advised to use an outdoor antenna for better reception. If you connect a monaural VCR, connect the yellow plug to (the yellow jack) and the black plug to -L (MONO) (the white jack). ⷠIf you connect a VCR to the (antenna) terminal, preset the signal output from the VCR to the program number 0 on the TV. CAUTION Do not connect the power cord until all other connections are complete; otherwise, a minimal current leakage through the antenna and/or other terminals to the ground could occur. [. . . ] The on-screen display for the picture and sound information disappears after about 3 seconds. Press until the desired period of time appears. Select the TV program or video mode you want to wake up to. Press u or set the Sleep timer if you want the TV to turn off automatically. Press until "WAKE UP TIMER: OFF" appears, or turn off the TV's main power. notes · The Wake Up timer starts immediately after the on-screen display disappears. ⷠIf no buttons or controls are pressed for more than two hours after the TV is turned on using the Wake Up timer, the TV automatically goes into the standby mode. To resume watching the TV, press any button or control on the TV or the remote. Press until the desired period of time appears. Press until "SLEEP TIMER: OFF" appears, or turn the TV off. Customizing the picture and sound You can customize the picture and sound by selecting the picture and sound modes or by adjusting its settings. You can change the sound effect by selecting the surround mode. Press PIC MODE repeatedly until you get the desired picture mode. Press SOUND MODE repeatedly until you get the desired sound mode. To listen to dynamic and clear sound that emphasizes the low and high sound. Listen to sound that emphasizes voice and background music. Adjusting the picture and sound settings Each time you press SELECT, the setting items change as follows: To adjust other items, repeat steps 1 and 2. When you select a picture or sound mode, the adjusted settings will be reset according to the selected mode. tip · You can also use SELECT and ¸ +/­ on the TV to adjust the picture and sound settings. To listen to sound that spreads out over a large area, giving the feeling of being at a movie theatre. Listen to the sound that gives the feeling of being at a live concert. You can display six of your favorite channels for quick and easy selection. [. . . ] If there is a problem with your TV, the u (standby) indicator flashes red. The number of times the u indicator flashes indicates the possible causes. Check that the u indicator flashes red once or more in intervals of 3 seconds. Count the number of times the u indicator flashes. [. . . ]