User manual SONY KV-1392R

[. . . ] Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. If the plug supplied is not suitable for the socket outlets in your home, it should be cut off and an appropriate plug fitted in accordance with the following instructions: The wires in this mains lead are coloured in accordance with the following code: Blue Neutral Brown Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] After 15 minutes without a signal and without any button being pressed, the TV switches automatically into standby mode. Back to the channel last watched Press to watch the last channel selected (watched for at least 5 seconds). displaying the menu system Press to display the menu on the TV screen. Press again to remove the menu display from the TV screen. Menu selection Scroll Up Scroll Down Previous menu or selection Next menu or selection OK confirms your selection Selecting Screen format Press to view programmes in 16:9 mode. Make sure to insert the supplied batteries using the correct polarities. Always remember you dispose of used batteries in an environmental friendly way. For a better reception we recommend you connect an external aerial. However, where an external aerial is not available and your local UHF signal is strong you can connect the supplied loop aerial as follows: 1 Insert the loop aerial into the opening on top of the set until it clicks. For more details of VCR connection, please refer to the section "Connecting Optional Equipment" of this instruction manual. The first time you switch on your TV, a sequence of menu screen appear on the TV enabling you to: 1) choose the language of the menu screen, 2) search and store all available channels (TV Broadcast) and 3) change the order in which the channels (TV Broadcast) appear on the screen. â· One minute before the TV switches itself into standby mode, the time remaining is displayed on the TV screen automatically. ON TIMER The "On Timer" option in the "Timer" menu allows you to select a time period for the TV to switch itself automatically on from standby mode. To do that: after selecting the option press , then press or to set the time period delay (max. Any loss of power will cause these settings to be cleared. LANGUAGE The "Language" option in the "Set Up" menu allows you to select the language that the menus are displayed in. To do that: after selecting the option, press and then proceed in the same way as in the step 2 of the section "Switching On the TV and Automatically Tuning". AUTO TUNING The "Auto Tuning" option in the "Set Up" menu allows you to automatically search for and store all available TV channels. To do that: after selecting the option, press and then proceed in the same way as in steps 3 and 4 of the section "Switching On the TV and Automatically Tuning". PROGRAMME SORTING The "Programme Sorting" option in the "Set Up" menu allows you to change the order in which the channels (TV Broadcast) appear on the screen. To do that: after selecting the option, press and then proceed in the same way as in step 5 b) of the section "Switching On the TV and Automatically Tuning". By one to the programme order of your choice. [. . . ] To cancel this function afterwards, select "Off" instead of "On" in the step above. NOISE REDUCTION The "Noise Reduction" option in the "Advanced Features" menu allows you to reduce the picture noise in case of a weak broadcasting signal. To cancel this function afterwards, select "Off" instead of "On" in the step above. " option in the "Advanced Features" menu allows you to keep the same volume level of the channels, independent of the broadcast signal (e. [. . . ]