User manual SONY KV-1923

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not install the TV where it may be exposed to mechanical vibrations. ⷠDo not keep the TV plugged in if you are not going to use it for several days. ⷠDo not pull the power cord to disconnect the TV. [. . . ] To scan through program positions Press PROGR +/­ on the remote commander or the TV until the program position you want appears. To turn off the TV temporarily Press POWER on the remote commander or the TV. When the TV is turned on in the standby mode, the POWER indicator on the TV lights up. To turn on the TV completely, press POWER on the remote commander or the TV. When the TV is turned on completely, the PROGR +/­, VOLUME +/­, and TV/VIDEO indicators on the TV light up. To turn off the TV completely Press MAIN POWER on the TV. To watch TV Press TV on the remote commander or TV/VIDEO on the TV. You can set the TV to turn on automatically after the period of time you want. After 12 hours If you want a particular TV program or video mode to be displayed using the Wake Up Timer, select the TV program or video mode. Press POWER on the remote commander or the TV, or set the Sleep Timer to turn off the TV in the standby mode. To cancel the Wake Up Timer, press WAKE UP/ INDEX repeatedly until "WAKE UP TIMER: OFF" appears, or turn off the main power of the TV. The sound mode of the TV program or the video input changes to the POWER BASSO sound. You can select any of the surround sound modes (HYPER SURROUND) to cancel the POWER BASSO sound. Listening to the surround sound (HYPER SURROUND) The HYPER SURROUND feature enables you to enjoy a surround sound effect that is like being in a concert hall or movie theater when receiving stereo signals. Listen to a sound that emphasizes the bass audio effect of movie theater. Listen to a dynamic and clear sound that emphasizes the low and high audio effect. listen to a sound that emphasizes voice. Listen to a sound that spreads out over a large area, giving the feeling of being at a concert hall. Listen to a monaural sound that gives a stereo-like effect. If the signal is very weak, the sound becomes monaural automatically. ⷠIf the stereo sound is noisy when receiving a NICAM program, select "MONO. " The sound becomes monaural, however, the noise will be reduced. [. . . ] To restore the normal screen Select STROBE again or PIP : OFF from the PIP menu, and press ENTER. You can change the position of the nine sub screens using the PIP menu (as described in "Changing the position of the PIP screen" on page 23). ⷠYou can hear the normal sound when using the STROBE feature. When you display a video input on the PIP screen at an abnormal speed, the picture may be noisy depending on the VCR. [. . . ]