User manual SONY KV-1928R

[. . . ] However, some TVs may have features which need the TV to be left in standby to work correctly. The instructions in this manual will inform you if this applies. Never push objects of any kind into the set as this could result in a fire or electric shock. Never spill liquid of any kind on the set. [. . . ] Alternatively, if you know the channel number, you can use the 0 - 9 buttons on the remote control to enter the channel number directly. When the channel you wish to add or delete is highlighted, press the OK button. This will either add a to show the channel is now stored as a favourite, or remove the existing . A display appears asking you to confirm you wish to delete all favourites. The index page (usually page 100) provides information on how to use the service. Please ensure you are receiving a strong signal or some text errors may occur. The screen is divided into two with the Text display on the left and the TV channel in the right corner. Notes: If you wish to view the Text in full screen mode, press the Press the numbered buttons to enter a three digit number for the text page you wish to view. Enter more 3 digit page numbers as required. How to use Text features A text page can consist of several sub pages. In this case an information box is displayed at the bottom of the screen showing the number of sub pages available. sharpness: Optimizes the sharpness levels of the TV picture. Press V or v to select `Low' (Demo) or `High', then press OK to confirm your choice. Note: As this is a demonstration only, any changes made are not stored. Press V or v to select `On' or `Off' then press OK to confirm your choice. 100Hz Mode: This option allows you to choose the best setting to view moving images. press V or v to select `100Hz Digital Plus' or `Adv. 100Hz Digital Motion' then press OK to confirm your choice. This menu allows you to customise the sound. highlight the required option and press b to select. The table below explains each option and how to use it. Sound Effect This option allows you to select one of four sound modes. [. . . ] Button on the remote control until either the VCR green light or the DVD green light illuminates. With the required green light illuminated, press and hold down the > button for approximately 6 seconds, until the lights start to flash. Using the numbered buttons, enter the 3 digit code for your DVD or VCR. Once a correct number has been entered, all three green lights will illuminate momentarily. [. . . ]