User manual SONY KV-2024AE

[. . . ] For environmental and safety reasons, it is recommended that the TV set is not left in standby mode when not in use. Never push objects of any kind into the set as this could result in a fire or electric shock. Never spill liquid of any kind on the set. If any liquid or solid object does fall through, do not operate the TV. [. . . ] Select Reset and press OK to reset the picture to the factory preset levels. SOUND ADJUSTMENT The "Sound Adjustment" menu allows you to alter the sound adjustments. To do this: after selecting the item you want to alter, press . Then press repeatedly / / or to adjust it and finally press OK to store the new adjustment. Enhances clarity, detail and presence of sound by using "BBE High Definition Sound system"*. Dynamic: "BBE High Definition Sound system"* intensifies clarity and presence of sound for better intelligibility and musical realism. Resets the sound to the factory preset levels. Off: volume level changes according to the broadcast signal. On: volume level of the channels will stay the same, independent of the broadcast signal (e. If you are listening to the TV through headphones, the "Effect" option will automatically be switched to "Off". **This TV has been designed to create the "Dolby Surround" sound effect by simulating the sound Of four speakers with two speakers, when the broadcast audio signal is Dolby Surround encoded. Press or to select on which programme number you want to preset the channel (for VCR, select programme number "0"). 2 The following option is only available depending on the country you have selected in the "Language/Country" menu. After that, press the number buttons to enter directly the channel number of the TV Broadcast or the channel of the VCR signal. If you do not know the channel number, press or to search for it. When you tune the desired channel, press OK twice to store. Repeat all the above steps to tune and store more channels. B) Label a channel using up to five characters. To do this: Highlighting the Programme option, press the PROG +/- button to select the programme number with the channel you wish to name. When the programme you want to name appears on the screen, select the Label option and press . Next press or to select a letter, number or "-" for a blank. After selecting all the characters, press OK twice to store. [. . . ] If Media Selector is on TV position, code numbers will not be stored. Before the green light goes out, press and hold the yellow button for approximately 6 seconds until the green light starts flashing. Whilst the green light is flashing, enter all three digits of the code for your brand using the number buttons on the remote control. If your selected code is entered correctly, all three green lights will be lit momentarily. [. . . ]