User manual SONY KV-2092R

[. . . ] the position values of the DPW are set to '0'. If other values are set, the complete combination will be scrolled. Take care not to connect too many appliances to the same power socket as this could result in fire or electric shock. For environmental and safety reasons, it is recommended that the TV set is not left in standby mode when not in use. [. . . ] Repeat step 2 for all the items you wish to have in your list. When finished with the list, select using B and press OK. Select a future programme in the column programme list using v or V. Address Mapping The position of the addresses in the OSDA is shown in the following diagram. the position values of the DPW are set to '0'. If other values are set, the complete combination will be scrolled. You may wish to record the selected programme with your VCR. This information is transferred to the VCR connected to your set. With this setting on, you have the guaranteed recording of the whole broadcast should there be a change in the TV programme. This only works if the selected channel broadcasts a VPS/PDC signal. With longplay you can record twice as much on a videotape. Press b or B to select the first or second column. These displays will help you get the most from your TV, helping you to change picture and sound settings, to alter the size of the TV picture and to rearrange the TV channels etc. Adjusting the picture and sound The picture and sound are preset at the factory. You can however adjust them to suit your own taste. Press the v or V buttons to select for picture settings or for sound settings then press B to enter either the `Picture Adjustment' menu or the `Audio Adjustment' menu. Press the v or V buttons to select the item on the screen you wish to adjust then press B to confirm. As soon as you have adjusted the item, press the OK button to store the new setting. Repeat steps 3-5 if you wish to adjust any of the other items. US video tapes) Reset AI (Artificial Intelligence) Resets picture to the factory preset levels V v Noise Reduction V v Digital Mode V On: Off: On: Off: Automatic optimization of contrast level according to the TV signal. Reduces picture noise in case of a weak broadcasting signal. Finally, press the OK button to store the new adjustment. [. . . ] Repeat steps 4-8 for the other AV input sources then press the MENU button to remove the menu from the TV screen. Using the illustrations below, you can connect a wide range of audio and video equipment to your TV. To view the input signals of connected equipment, please follow the instructions below. Using the illustrations above, connect your equipment to the appropriate TV socket. [. . . ]