User manual SONY KV-20TS27

[. . . ] Take care not to connect too many appliances to the same power socket as this could result in fire or electric shock. For environmental and safety reasons, it is recommended that the TV set is not left in standby mode when not in use. However, some TVs may have features which require they are left in standby. The instructions in this manual will inform you if this applies. [. . . ] To do this: After selecting the item you want to alter press the b button, then repeatedly press the v/V/B or b buttons to make any adjustments and finally press the OK button to store. This menu also allows you to customise the picture mode based on the programme you are watching: v Personal (for individual settings). Select Reset and press the OK button to return the picture settings to their factory preset levels. Level 3 / Function SOUND ADJUSTMENT The "Sound Adjustment" menu allows you to alter the sound settings. To do this: After selecting the item you want to alter press the b button, then repeatedly press the v/V/B or b buttons to make any adjustments and finally press the OK button to store. Enhances clarity, detail and presence of sound by using the "BBE High Definition Sound system"*. "BBE High Definition Sound system"* intensifies clarity and presence of sound for better intelligibility and musical realism. Resets the sound to the factory preset levels. V Off: volume level changes according to the broadcast signal. V On: volume level of the channels will stay the same, independent of the broadcast signal (e. If you are listening to the TV through headphones, the "Effect" option is automatically switched to "Off". To cancel this function later on, select "Off" instead of "Auto" in the step above. Level 3 / Function MANUAL PROGRAMME PRESET The "Manual Programme Preset" option in the "Set Up" menu allows you to: a) Preset channels or the VCR channel one by one to the programme order of your choice. to do this: 1 After selecting the "Manual Programme Preset" option , press the b button then with Programme option highlighted press the b button. Press the v or V buttons to select which programme number you want to preset the channel to (for VCR, select programme number "0"). 2 The availability of this option depends on the country you have selected in the "Language/Country" menu. After that, press the numbered buttons to directly enter the channel number of the TV Broadcast or the VCR channel. If you do not know the channel number, press the v or V buttons to search for it. When you have tuned to the desired channel, press the OK button twice to store. Repeat all the above steps to tune and store more channels. B) Label a channel using up to five characters. To do this: After highlighting the Programme option, press the PROG +/- button to select the programme number of the channel you wish to name. [. . . ] Therefore, please refer to code table included with the remote control for the latest code set. 1 Press the Media Selector button repeatedly on the remote control until the required VCR or DVD green light is lit. Note: If the Media Selector button is switched to TV, the code numbers will not be stored. 2 With the green light illuminated, press and hold down the YELLOW button for approximately 6 seconds until the green light starts to flash. [. . . ]