User manual SONY KZ-32TS1E

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Then press or to select After selecting the option, press Off and finally press OK to store. Sound of the TV is not output through the TV's speakers. Orbit Range: Select the moving range from Large, Mid (Middle), and Small. Orbit Cycle: Select the moving time from 10sec, 30sec, 1min, and 5min. The "AV3 Output" option allows you to select the source to be output from the Scart connector 3/ S . You can record from this Scart any signal coming from the TV or from external equipment connected to the other Scart connectors. If your VCR supports SmartLink, this procedure is not necessary. If you select Auto, the output signal will always be the same one that is displayed on the screen. If you have connected a decoder to the Scart 3/ S or to a VCR connected to this Scart, please remember to change back the "AV3 Output" to Auto for correct unscrambling. When AV3 Output is set to Auto, the signal input through the AV5 input and the RGB signal are not output from the Scart connector 3/ S . The "AV3 Input, ""AV4 Input, " and "AV5 Input" options allow you to select which jack the TV receives the input signal from; Video or S Video for AV3 Input and AV4 Input, and Component or RGB for AV5 input. Then press After selecting the option, press the desired jack and finally press OK to store. Then press or to select the connected equipment: DTV for a digital tuner with RGB signal, or Others for other RGB equipment. The "Set Up" menu allows you to alter various options of this TV. The "Language/Country" option allows you to select the language that the menus are displayed in. It also allows you to select the country in which you wish to operate the TV set. To do this: and then proceed in the same After selecting the option, press way as in the steps 2 and 3 of the section "Switching On the TV and Automatically Tuning" on page 11. The "Auto Tuning" option allows you to automatically search and store all available TV channels. To do this: After selecting the option, press and then proceed in the same way as in the steps 4 and 5 of the section "Switching On the TV and Automatically Tuning" on page 11. The "Programme Sorting" option allows you to change the order in which the channels (TV Broadcast) appear on the screen. To do this: After selecting the option, press and then proceed in the same way as in the step 6 b) of the section " Switching On the TV and Automatically Tuning" on page 12. The "Programme Labels" option allows you to name a channel using up to five characters (letter or numbers). [. . . ] Keep the aerial cable away from other connecting cords. Do not use 300-ohm twin lead cables as interference may occur. Check if any connected optional equipment is installed in front of the TV or at the side of the TV. When installing optional equipment, leave some space between the optional equipment and TV. [. . . ]