User manual SONY LBT-D890AV

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This caution label is located inside the unit. This stereo system is equipped with the Dolby Pro Logic Surround system* and the Dolby B-type noise reduction system. [. . . ] Button (for the front side) lights up green. The required tape length for the CD in the playing position appears, followed by the total playing time for sides A and B. note You cannot use this function when Program Play mode has been set. After clearing the entire program (see "Clear the entire program" in the table on page 25), follow the above procedure. Select A to record on one side, or ß (or RELAY) to record on both sides. After the last track, "CHECK END" appears. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. With the loop function, you can repeat part of a CD during playback. This lets you create original recordings. With the flash function, you can "flash" the CD sound during playback. This lets you create original recordings. Playback at the point you want to start the Loop function, and release to resume normal playback. to adjust the loop length Turn the jog dial while holding LOOP (or press MUSIC MENU B/b while holding LOOP on the remote) to select different loop lengths. Playback at the point you want to start the Flash function, and release to resume normal playback. to adjust the flash length Turn the jog dial while holding FLASH (or press MUSIC MENU B/b while holding FLASH on the remote) to select different flash lengths. To use LOOP and FLASH together With the Wave function, you can fluctuate the graphic equalizer automatically while listening to a source. This effect can be used with any source, but it cannot be recorded. Listening to a source at the point you want to start the Wave function, and release to resume normal playback. to adjust the wave length Turn the jog dial while holding WAVE to select different wave lengths. You can reinforce the bass, create a more powerful sound, and listen with headphones. Each time you press this button, the super woofer mode display changes as follows: MOVIE ~ MUSIC The volume switches to power mode, the equalizer curve changes, the bass level (DBFB or SUPER WOOFER) changes to "HIGH, " and the indicator on the GROOVE button lights up. Press GROOVE again to return to the previous volume. [. . . ] inserting the vinyl portion of the speaker cord will interfere with the speaker connection. There is no microphone sound · Move the stereo system away from the TV or VCR. Sound comes from only one channel or the left and right volumes are unbalanced. There is no sound from the speakers except the center speaker. [. . . ]