User manual SONY LBT-DR330

[. . . ] Each time you press the button, the band changes as follows: FM ~AM The frequency indication changes and scanning stops when the system tunes in a station. To enhance your system, you can connect a turntable. Repeat steps 1 to 5 to store other stations. To tune in a station with a weak signal The preset stations are retained for a week even if you pull out the mains lead or if a power failure occurs. [. . . ] Playing the CD tracks in random order â­Â­ Shuffle Play You can play all the tracks on one CD or all CDs in random order. You can make a programme of up to 32 tracks from all the CDs in the order you want them to be played. "SHUFFLE" appears, then all the tracks play in random order. You can start Shuffle Play during normal play by displaying "SHUFFLE". You cannot select a CD even if you press DISC SKIP while shuffle play. Playing only the beginning of each track -- Music Scan The begining of each track on all the CDs in the CD tray play for 10 seconds. Skip step 3 if you select a track from the same disc. All the tracks play in the order you selected. To Programme a pause Stop play Cancel programme play Erase a track from the end Erase the entire programme To play only the begining of each track Track number blinks during the scanning. CLEAR on the remote in stop mode p for more than two seconds The programme you made remains after the Programme Play has finished. To play the same programme again, press · "FULL" appears when you have programmed more than 32 track numbers. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. â· Unplug the system from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Should any solid object or liquid fall into the component, unplug the stereo system and have the component checked by qualified personnel before operating it any further. â· The mains lead must be changed only at a qualified service shop. Use a soft cloth slightly moistened with mild detergent solution. To prevent a tape from being accidentally recorded over, break off the cassette tab from side A or B as illustrated. If you later want to reuse the tape for recording, cover the broken tab with adhesive tape. Place the stereo system in a location with adequate ventilation to prevent heat build-up in the stereo system. â· Do not place the unit in an inclined position. â· Do not place the unit in locations where it is; ­ Extremely hot or cold ­ Dusty or dirty ­ Very humid ­ Vibrating ­ Subject to direct sunlight. [. . . ] Play does not start from the first track. If the system malfunctions due to a cause other than the ones mentioned above This system coordinates its performance by using built-in microcomputer chips. Therefore there may be a case where the system does not operate properly if the condition of its power source etc. In such a case, turn the system's power off and then turn it on again. [. . . ]