User manual SONY LCJ-RXB DATASHEET

[. . . ] Using time* 50 minutes 20 hours ( Operating the system Note Do not hang the headphones by the self adjusting band, otherwise, the self adjusting band will be pulled up and the headphones will be switched on. Troubleshooting No sound/Muffled sound / Turn on the transmitter first, then put on the headphones. / Check the connection of the audio/video equipment or the AC power adaptor. / Check that the audio/video equipment is turned on. [. . . ] Refer to them whenever you call upon your Sony dealer regarding this product. Transmitter Headphones Right channel (red) Left channel (white) Setting up the headphones 1 Open the battery compartment lid on the left outer side of the head band. Charging the headphones’ batteries Connecting cord (supplied) 3 Put on the headphones and the power turns on automatically. unimatch plug adaptor (supplied) to headphones jack (stereo phone jack) to headphones jack (stereo mini jack) Discman , MD , WALKMAN* , VCR , etc. Using the headphones for the first time The headphones are powered by either supplied rechargeable batteries or commercially available size AA (R6) batteries. When you use the headphones with the supplied rechargeable batteries NC-AA-HJ for the first time, charge the batteries in the following manner. nC-AA-HJ is applicable only for Sony cordless/ wireless headphone systems. Distortion / If the transmitter is connected to the headphones jack, turn down the volume of the connected audio/video equipment. / Select the radio frequency with the CHANNEL selector. / The headphones’ POWER indicator light is weak or turned off. €¢ Charge the rechargeable batteries or if the POWER indicator is still off after charging the batteries, replace them with new NC-AA-HJ batteries. In this case, make sure the volume of the equipment connected is set to 5 – 6. You may not hear the beginning of the sound from the headphones until the transmitter starts sending the RF signals after detecting an audio signal. Note If the transmitter is connected to the headphones jack of the source equipment, set the volume of that equipment as high as possible without distorting the audio signal. 3 Close the battery compartment lid. 2 Place the new ear pad on the driver unit and insert the edge of the pad into the groove as illustrated. English WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. refer servicing to qualified personnel only. WARNING You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Notes on receiving performance The system for this equipment utilizes very high frequency signals in the 900 MHz band so the receiving performance may deteriorate due to the surroundings. The following examples illustrate conditions that may reduce the possible receiving range or cause interference with reception. [. . . ] Note: In some areas the disposal of nickelcadmium batteries in household or business trash may be prohibited. RBRC (Rechargeable Battery Recycling Corporation) advises you about spent battery collection by the following phone number. Call toll free number: 1-800-822-8837 (United States and Canada only) Caution: Do not handle damaged or leaking nickel-cadmium batteries. If noise occurs when the transmitter is connected to the headphone jack of your TV or VCR, set the NOISE FILTER switch to ON. [. . . ]