User manual SONY LCS-EMB30 DATASHEET

[. . . ] Please note that the software specifications are subject to change without notice. Some of the illustrations in this manual may differ from the actual application software. This manual explains networking operations when this device is attached to the Flat Panel Display, FWD series. Microsoft and Windows are the registered trademarks of Microsoft Corporation in the United States and/or other countries/regions. [. . . ] Remove the already installed option adaptor (for FWD-50PX1) or the panel cover (for FWD-50PX1N). FWD-50PX1N: Loosen the two screws located on the top and bottom of the panel cover. Use a Philips screwdriver to turn the screws counterclockwise, and then remove the panel cover. Check the direction (top/bottom) of this device and insert it into the flat panel display. Make sure that the connector inside the display is firmly connected. Using a slot screwdriver, tighten the two screws of this device. Doing so may result in injury to yourself or cause this device to malfunction. When you use this device connected to a LAN, you must set an IP address. Use this device in a DHCP environment in which an IP address is automatically obtained. You can confirm information such as the IP address that was set for this device on the Information page or the Unit Status page accessed using the menu of the Display unit. If the network environment is changed, you need to set up a new IP address again. When PICTURE MODE is set to User1 or User2, you can adjust the following items. Network Internet Protocol (TCP/IP) Under normal circumstances, set this item to "Obtain an IP address automatically (DHCP). " Enter the required value (address) if you set it to "Specify an IP address. " Password Names and Passwords can be set individually for the Administrator and each User. the Name for the Administrator is permanently set to "root. " Mail Report* If an error occurs in the Display unit, the system immediately reports the error by sending an E-mail (Error Report). A dialog box prompting you to enter a Network Password appears. "Name: root" is preset as the factory setting without a password. The settings entered or changed in each window become valid after you click Apply located near the bottom of the window. You cannot enter special characters in this window. Address (Destination) Enter an e-mail address in each text box. [. . . ] Check this check box and click Apply to send a test e-mail. If the following items are not set or the settings are incorrect, an error message appears and the test e-mail message cannot be sent. The Mail Address of the Mail Account and the address of the SMTP server Advanced (Advanced settings) Sets the advanced settings required to use various application software on the network. Refer to the setting requirements of the application software you want to use as well. [. . . ]