User manual SONY LF-X11 QUICK START

[. . . ] 2-655-609-11 (1) If you have additional questions related to the use of this product after reading this Quick Start Guide and the Operating Instructions, please call our LocationFreeTM Customer Support. [. . . ] In this case, perform these settings from the [Settings] window. For details, refer to "Configuring the On-Screen Remote for External Tuners on TV" in the operating instructions. Other devices (VCR, DVD players, etc. ) POWER LED STEP 2 1 Setup to Watch TV at Home In "Easy Setup (Basic)", follow the instructions on the screen and make the following settings. Remove the stylus from its compartment. 3 Select [Next]. 2 input terminal, 9 If you connect a device to the8, Videothen select [Next]. make the same settings as in step and z Tip The preceding settings are required for watching TV and video at home. From step 10 onward, the necessary settings for Internet and E-mail are configured. If you do not need to make Internet and E-mail settings, you can skip them by selecting [Next]. 10 Confirm that "OK" is displayed on the screen, and select [Next]. Make sure that the following icon appears in the upper right corner of the screen. antenna cable is to 4 Check that the [ON] or [OFF] for connectedandthe Base Station, select [CABLE], then select [Next]. If an external TV tuner or STB is connected with an AV cable, select [Skip Automatic Scan] and proceed to step 7. 2 Select [Go] on the "Welcome" screen. Network settings can also be configured from the [Settings] window. 11 appears, select 5 When a message Scan begins. Automatic Channel The "Welcome" screen only appears when starting up for the first time. For details on starting "Easy Setup" again after the first time, see "Start `Easy Setup' Manually" below. Refer to your ISP, make the E-mail settings, and then select [Next]. 6 When the channel scan finishes and a message appears, select [OK]. connections 7 Check the other deviceselect [Next]. and IR Blaster connections, and then Start "Easy Setup" Manually When the "Welcome" screen does not appear, perform the following steps to start "Easy Setup". Touching any character entry field will cause the on-screen keyboard to appear. 1 Touch anywhere on the screen and select [Settings] at the bottom right of the screen. where you will use the 12 Select the time zone for the areadate and time with [+] and LocationFree TV, set the current [­], and then select [Finish]. 2 Display the [Settings] window, and then select [Easy Setup]. [. . . ] 4 Read the "Dynamic DNS Terms-of-Use TV Agreement" included in the LocationFree carton box, select [Agree], and then select [Next]. It takes approximately one minute for the NETAV LED to turn off. 4 Connect the Monitor to the Internet according to your operating environment. For details, refer to the operating instructions and Instructional DVD. [. . . ]