User manual SONY LIB-81

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] With a coin, remove the transport screw from the library bottom and set it in the bottom hole (safe position). Remove the transport screw by turning it counterclockwise. In addition to the above, other documentation and papers may also be included in the package. ⷠThese instructions (this Quick Start Guide) are also included in PDF format on the CD-ROM. Before installing the library, make sure that the surface on which you are placing it is large and strong enough. Confirm that the power switch on the rear of the AIT library is turned off (a is pressed). Also, set the library horizontally so that its front and sides are inclined by no more ±1 degree in any direction. Connect one end of the power cable to the power supply connector and the other end to the electric outlet. With the rack mounting kit, ACY-RK2 (sold separately), the AIT library can be installed on an EIA_STANDARD 19-inch rack. Contact your dealer for information about the rack mounting kit. Install the AIT library on a horizontal surface near an AC power outlet. ) behind the rear of the unit to allow air to circulate. To connect, use the Ultra2 Wide SCSI LVD cable sold at stores. However, when using a model equipped with an AIT-3 drive, use an Ultra 160/m SCSI LVD cable. [. . . ] When the startup process ends, the library enters the time setting mode. If you do not want to make changes, press the [CANCEL] button. for details about the date and time settings , refer to "Setting the Date and Time" in "Installation" in chapter 2 , in the "Operating Instructions" (PDF). [. . . ]