User manual SONY LMD-1041

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] Clean the cabinet, panel and controls with a soft cloth lightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or benzine. Do not drop or step on the remote commander. Keep liquid away from the remote commander. Do not place the remote commander under direct sunlight, near heat sources or in a humid place. (The LCD angle against field of view does not change. (The LCD angle against field of view is adjusted. Shows the index number of the unit (page 11). You can assign an index number to each unit. When two or more units are installed at the same location, use this index number to select a unit you want to control using the remote commander. Switches the size and viewable area of the image. After selecting a parameter with these buttons, adjust with the +/­ buttons 4. Each time you press the button, the RGB signal mode and YUV (Y/B-Y/R-Y) signal mode switches. in the RGB signal mode , the computer mode or the VIDEO RGB mode switches automatically depending on the input signal. Note on the computer signal The characters may have colored shade in some horizontal sizes. Lights in green when the POWER switch 7 is turned on. Lights in red when the POWER switch 7 is turned off. The following table shows which parameters can be adjusted for each input signal. Yes: You can adjust (Only possible in under-scan mode appears in parenthesis) No: You cannot adjust Input signal Parameter button INDEX U SCAN V POS H PH H SIZE H POS SHARP COLOR HUE PIC LIGHT BRT RESET VOLUME +/­ MUTING * For NTSC only Yes Yes No Yes No (Yes) No (Yes) Yes Yes Yes * Yes Yes Yes Yes Yes Yes Yes Yes No Yes No (Yes) No (Yes) Yes Yes Yes * Yes Yes Yes Yes Yes Yes LINE A LINE B Computer Yes No Yes Yes Yes Yes No No No Yes Yes Yes Yes Yes Yes LINE C Video RGB Yes Yes No Yes No (Yes) No (Yes) No No No Yes Yes Yes Yes Yes Yes YUV Yes Yes No Yes No (Yes) No (Yes) Yes Yes Yes * Yes Yes Yes Yes Yes Yes Turns on or off the main power of the unit. It is then possible to control the whole system with a single remote commander. You can hang the unit on the wall, or attach the stand and place on a table. You can attach the Kensington's security cable (not supplied). [. . . ] 43 RGB: Operating frequency: fh: 15 kHz -- 36 kHz fv: 45 Hz -- 73 Hz Audio signal level Audio input: ­5 dBs, 47 k or more Headphones output: 16 or more Speaker output: 0. 3 V) RGB signal input level Separate Sync: TTL level, negative, positive Composite Sync: TTL level, negative Sync-on-Green: 0. 2 kg (4 lb 7 oz) Supplied accessories Remote commander (1) R6 (size AA) batteries for remote commander (2) Stand (1) Screws to secure the stand (2) Plate (1) Power cord (1) Design and specifications are subject to change without notice. This section may help you isolate a problem and, as a result, eliminate the need to contact technical support, allowing continued productivity. [. . . ]