User manual SONY M-635VK

[. . . ] Insert a cassette with the side to start playing facing the lid. Select the tape speed to the same speed as that used for recording. Keep mCUE/MREVIEW pushed down during playback and release it at the point you want. Keep mCUE/MREVIEW pushed up during playback and release it at the point you want. [. . . ] For M-635VK Replace the batteries with new ones when the BATT lamps go off and the E lamp flashes. The unit will play back normally for a while, even after the E lamp flashes. However, replace the batteries as soon as you can. If you do not, the playback cannot be made with normal sound, noise may be recorded and the recorded sound will not be loud enough (M-635VK only). In the following cases you do not need to replace the batteries: ­ if the REC/BATT or BATT lamp, or BATT lamps flash with the playback sound when you turn up the volume. ­ if the E lamp lights momentarily when the tape starts running or at the end of the tape (M-635VK only). Rewind Search forward during playback (CUE) Search backward during playback (REVIEW) * If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. If the tape is completely wound or rewound while searching forward/ backward during playback (CUE/REVIEW), the mCUE/MREVIEW switch may not return to the center position when you release the switch. In this case, push back the switch to the center to start playback. If you plug in headphones (not supplied) to the EAR jack, you will get monaural output from both left and right channels. To return to the original speed, slide the FAST PB switch to the original position. Press or slide xZ z during playback (the unit becomes in the recording mode) Push up mCUE/MREVIEW toward MREVIEW during the recording. Use a microphone of low impedance (less then 3 kilohms) such as ECM-T6 (not supplied). When using a plug-in-power system microphone, the power to the microphone is supplied from this unit. note When recording with an external microphone, the VOR system may not work properly because of the difference in sensitivity. 24 mV for 3 kilohms or lower impedance microphone Output Earphone jack (minijack) for 8 ­ 300 ohms earphone Power output (at 10% harmonic distortion) M-635VK/540V: 250 mW M-430: 160 mW Power requirements 3 V DC batteries R6 (size AA) × 2/External DC 3V power sources Dimensions (w/h/d) Approx. 5 oz) Supplied accessories Microcassette tape MC-30 (1) (M-635VK/540V for Europe only) Batteries R6P (SR) (2) (M-635VK for Europe and "Sony World Model" only) Carrying pouch (1) (M-635VK for Europe and "Sony World Model" only) Design and specifications are subject to change without notice. Use only the (standard microcassettes) with this unit. Non-standard cassettes cannot be used because their "L" dimension (see illustration) is different (see Fig. Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further. Keep personal credit cards using magnetic coding or springwound watches etc. [. . . ] Keep personal credit cards using magnetic coding or springwound watches etc. Away from the unit to prevent possible damage from the magnet used for the speaker. When you do not use the unit for long, remove the batteries to avoid damage caused by battery leakage and subsequent corrosion. If the unit has not been used for long, set it in the playback mode and warm it up for a few minutes before inserting a cassette. [. . . ]