User manual SONY MCS1

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Dangerously high voltages are present inside the unit. The model number and the serial number are located on the bottom of the drive. Record the serial number in the space provided below. [. . . ] To view digital images in a digital still camera, connect the camera to the MCS1 using the USB cable supplied with the camera. When displaying digital images from CD-R, the following indication appears in the display window of the MCS1. If several media are available to the MCS1 at the same time, you can use the MODE button to select one of them. When you perform this procedure, an index of six digital images first appears on your television screen. You can perform the following in the index with the MCS1 controls. Use the T/t buttons to move the cursor to the desired digital image. While an image is displayed full-screen, you can use the T/t buttons to display the previous or next image. As long as a disc has not been finalized, you can add more data to it until the disc capacity is reached. The steps for adding data are basically the same as when writing data for the first time (using a new disc), except for the following points. Place the next CD-R in the MCS1 and close the cover. Repeat steps 1 to 3 until the following indication appears in the display window. The procedure comprised of steps 1 to 3 can be repeated until all the data is copied. After data is written to a CD-R, the procedure of locking the remaining area so that no more data can be written is called finalization. This enables most other devices such as computers, CD-ROM drives, etc. After it is finalized, no more data can be added to a CD-R, even if there is still some free capacity. Note Even when a disc is finalized, some computers or CD-ROM drives may still not be able to play the disc. If you experience problems, try reading the disc in another computer or CDROM drive. Hold down the POWER button for at least 2 seconds to turn the MCS1 on. Press the MODE button several times until the following indication is shown in the display window. When finalization is completed, the display window changes to "FINISHED". You can connect a USB storage media to the USB connector of the MCS1, and copy all the data it contains to CD-R. To do so, follow the same procedure as the one outlined in "Copying data from a digital still camera" on page 14. [. . . ] C If the image is not in JPEG format (such as TIFF or other format files), the MCS1 cannot display it on the television. C Make sure that the television or video to which the MCS1 is connected is displaying the correct input channel. C The video output signal may not be set to the correct format (NTSC/ PAL). Select the correct setting for your country or region (page 27). [. . . ]