User manual SONY MDM-X4

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] press the REC SELECT key for tracks 1 and 2. This makes it possible to record on tracks 1 and 2. The track editing operations let you specify a part (an arbitrary section of an arbitrary track) and copy it over another part, move it to another position, or remove the sound from it. You can also switch the positions of two parts. Additionally, you can edit between different songs as well as within the same song. Before editing, it is necessary to specify the locate points (edit points). There are the following eleven types of locate points: · DEST (edit destination) point Represents the place where the part will be copied to during the copy operation (etc. Using the Undo Function with track editing operations You can undo an edit immediately after execution if the undo indicator is lit green. to carry out the undo function , press UNDO. Pressing undo again lets you redo the undone edit operation (redo function). note Carrying out another edit operation, starting a recording, or removing the disc after carrying out the undo or redo functions will make it impossible to undo the previous edit operation. Use the following procedure when you know the time/bar of the locate points for the desired part. The color which the indicator on the UNDO key lights shows the current status. ) RED : undo has been carried out (blinking) : in the process of carrying out the undo (or redo) function. (In cases where the previous operation cannot be undone (etc. Turn the jog dial during stop mode to display the time/bar you desire. Holding down the SHIFT key and pressing the DISPLAY key lets you switch the display between time and bars. To select the desired song, use the = and + keys. Press the key for the locate point you desire. DEST (destination) point : Hold down the SHIFT key and press IN. A~D (E~H) points : Press A~D (Hold down the SHIFT key and press A~D). Setting edit points while listening to the sound being played back Use the following procedure to set locate points while listening to the sound being played back. [. . . ] ATRAC cuts the sounds imperceptible by the human ear to compress the data to 1/5 the original size. Since the data is chosen for reduction is based on psycho acoustic principles there is no perceivable effect on the sound quality. This unit has treble (HIGH), middle (MID), and bass (LOW) adjustments. The group bus (1~4) carries the sound to the respective tracks in the recorder, the stereo bus (L and R) carries the sound to the STEREO OUT jacks, and the CUE bus carries the sound recorded on the tracks to the MONITOR OUT jacks. [. . . ]