User manual SONY MDR-DS6000

[. . . ] To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To reduce the risk of fire or electric shock, do not place objects filled with liquids, such as vases, on the apparatus. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This product shall exclusively be used inside buildings. [. . . ] Processor To audio output jacks To LINE IN jacks Audio left (L, white) Audio left (white) VCR, TV, or other component Connecting cables (sold separately) Use the connecting cable (stereo mini-plug y pin plug × 2) when connecting a stereo mini-jack (line out jack or headphone jack) to the LINE IN jacks. In this case, set the volume on the player at a medium level. Noise can occur if the volume on the player is set too low. Setting the input level If the volume is low using the analogue input, set the ATT (attenuator) switch to "0 dB. TV, portable components, and other components with a low output level Other components (initial settings) Be sure to lower the volume before setting the ATT switch. If audio input to the LINE IN jacks is distorted (sometimes, noise can be heard at the same time), set the ATT switch to "­8 dB. Before starting, be sure to read "Connecting the Headphone System" (pages 15 to 17) and make the proper connections. The processor turns on automatically and the RF indicator blinks for about 5 seconds. The processor automatically detects the optimum frequency for transmission according to your room conditions. The RF indicator lights up when emission from the processor starts. Then the DECODE MODE indicator lights up, depending on the audio signal input from the connected audio or video component and the setting of the EFFECT switch. Signal transmission system This unit employs a proprietary transmission system using 2. You can enjoy non-compressed sound with this wireless system. The POWER indicator lights blue, and the headphones automatically turn on. Be sure to match the right and left side of the headphones with your ears and wear the headphones at the correct angle so that the Auto Power On/Off function works correctly. Sound is heard from the headphones about 3 seconds after you put on the headphones. Note To listen to dual audio (MAIN/SUB) sound sources, connect to the LINE IN jacks, and then select the sound source you want to listen to on the player, TV, or other component. Sound field and suitable sound source normal playback of the headphones. Produces the kind of surround sound that is found in a typical movie theatre. Produces the kind of sound field that would be found in a listening room with good acoustics. When the EFFECT switch is selected, the sound mode changes to the selected effect. Any noise you hear through the headphones may vary depending on the processor position and room conditions. [. . . ] Check if there is any wireless apparatus using 2. , There is no audio signal input for about 5 minutes and RF signals are not transmitted. Other devices (wireless LAN, cordless phone, etc. 4 GHz frequency around the processor become unusable. [. . . ]