User manual SONY MDR-E818LP

[. . . ] record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Dust at the ends of the cable can degrade performance. When storing the system, attach the cap to the end of the plug and be careful not to fold or bend the optical digital connecting cable with a bend radius less than 25 mm. The bend radius of the optical digital connecting cable should be at least 25 mm. Use an audio cord (sold separately) to connect to the audio output jacks on the VCR, TV, or other component to the LINE INPUT (L/R) jacks on the digital surround processor. Digital surround processor VCR, TV, or other component To LINE INPUT jacks Audio left (L, white) To audio output jacks Audio left (white) Connecting cables (sold separately) Use the RK-G129 cable (stereo mini-plug ~ pin plug x 2) when connecting the stereo mini-jack (line out jack or headphones jack) to the LINE INPUT jacks. In this case, set the volume on the player at around 5 to 7. Noise can occur if the volume on the player is set to a low setting. Setting the input level If the volume is low using analog input, set the ATT (attenuator) switch to "0dB". TV, portable components, and other components with a low output level Other components (initial settings) Be sure to lower the volume before setting the ATT (attenuator) switch. Plugging into the wall outlet AC power adapter To the wall outlet Be sure to use the supplied AC power adapter. Using AC adapters with different plug polarity or other characteristics can cause product failure. This mode is suitable for music sources. Note If the output mode (sound effect) is set to "OFF" in step 5 on page 21, you cannot select a sound field even if you press EFFECT. Note When watching movies, be careful not to raise the volume too high in quiet scenes. You can hurt your ears when a loud scene is played. The headphones automatically turn off when they are taken off -- Auto Power On/Off Function When not using the headphones, be sure that the self-adjusting band is no longer pulled up. The power stays on when the self-adjusting band is pulled up. to check the remaining battery power Pull up the self-adjusting band and check the POWER indicator. The batteries can be used when the POWER indicator lights red. Charge the batteries or use new dry-cell batteries if the POWER indicator is faint, the sound is distorted, or increased noise is heard. After using the headphone system Turn off the digital surround processor first before turning off the component connected to the digital surround processor. If you turn off the connected component first, the infrared beam is cut off and noise may be emitted (this is not a malfunction). [. . . ] The surround effect does not work for monaural and other sound sources which have not been processed for surround sound. / The audio digital output setting for the DVD player may be set to "PCM". Refer to the instruction manual supplied with the DVD player, and change to the setting (such as "Dolby Digital/PCM" or "Dolby Digital") for usage with components having built-in Dolby Digital (AC-3) decoders. / You are trying to play DVD software not compatible with Dolby Digital 5. [. . . ]